20 Most Recent
Questions & Answers
I have a Zebra 105
Calibrate the printer from the setup menu.
You'll (1) Load the label backing with the ribbon (2) remove the ribbon - just shove it to the right, out of the way of the ribbon sensor (3) reload the label and ribbon.
The printer will run a number of labels out.
on Jun 17, 2016
HI, our Zebra 4m+ is
Full resin ribbons tend to require higher darkness settins on all thermal printers.
It could be a mismatch between label and ribbon. This would need to be looked by your supplier.
on Nov 28, 2014
Not finding what you are looking for?