20 Most Recent Samsung CLP-510 Laser Printer Questions & Answers


This can happen if you install a CLP-500 cartridge OR a Xerox Phaser 6100 cartridge.

Physically they are the same, but the 'chip' is different.

In the case of the Xerox, it is the programing of the chip that 'tells' the printer its a Xerox cartridge, and the printer won't accept this as valid.

If it's a CLP-500, the three contacts on the side of the cartridge have a resistor (for the capacity of the cartridge) and a falmeproof fusible resistor which resets tha page counter (for that cartridge) when a new cartridge is installed.

Samsung CLP-510... | Answered on Jul 05, 2017


to reset the counter on the toners and transfer belt see:
http://www.dunfield.com/clp510/

Samsung CLP-510... | Answered on Jun 27, 2017


If this IS a CLP-510, first make an information confirmation print.
Press MENU, then press ENTER, and ENTER again.

Look at the counter for the imaging unit, is it a low count confirming that you have indeed replaced it ?
If not you will need to reset the counter.

Check the counters for the toner cartridges, and check the capacity of the cartridge. On a CLP-510 the image counter for the toner is held on the chip on the cartridge (which also identifies the capacity of the cartridge).

There have been some faulty (oiginal Samsung chips), and of course re-manufactured cartridge chips could fail (many re-manufacturers don' test their cartridges before dispatch, they don't have the facility to do so without starting the count on the chip (or 'bowing' the reset fuse on a CLP-500 cartridge). VERY few re-manufacturers can test these cartridges without starting the count.

Sometimes the 'replace xxxxx toner' messages are caused by toner on the three contacts on the side of the cartridge, or their mating contacts inside the printer. Rarely, this can be caused by a faulty circuit board.

Samsung CLP-510... | Answered on Feb 23, 2017


when using heavier quality paper , you have to set the paper thickness in the printer settings option section

Samsung CLP-510... | Answered on Nov 12, 2015


You can check the level of each item.
1. In ready mode press the Menu button on the control panel everal times until you see 'Setup 'on the bottom line
of the display.
2 Press the Enter button to access the menu.
3 Press the scroll button until 'Maintenance ' displays on the bottom line.
4 Press the Enter button
5 When 'Check Others ' displays on the bottom line,,press the Enter button .
6 Press the scroll button until the item you want to check displays on the bottom line.
7 Press the Enter button The display shows the percentage of item.
8. Press the scroll button display either 'Image Count' or 'Reset'
9a. Choose 'Reset' and press enter to reset the counter after replacing a consumable item
or
9b Choose Image count to display the counter.
10. Press the Upper Level button to return to step 7 and select a different choice or press it a second time to return to step
6 and choose a different item.
11. To return to the Ready condition press the Upper Level button several times until 'Ready' appears in the display.

Samsung CLP-510... | Answered on Oct 02, 2015


  • Most likely there is a scratch on drum of imaging unit
  • or scratch or dust on transfer belt
  • or dust on LSU

Check all these , should get resolved.

Samsung CLP-510... | Answered on Sep 03, 2015


Might be the same problem that we see on the CLP 310s. Bad exit sensor. Go to YouTube and watch this video: 5fJHykzkfww

You can get the part on eBay for about $10 and it's a fairly simple 15 minute fix.

Samsung CLP-510... | Answered on Apr 26, 2015


put tape across the 3 contacts on the side of the cartridge, reinsert cart into printer, restart printer, holding down the Menu key until a message "Uncheck consumables" appears, then let Menu key up.

Samsung CLP-510... | Answered on Dec 08, 2014


http://www.samsung.com/us/support/owners/product/CLP-510

Samsung CLP-510... | Answered on Nov 24, 2014


REPLACE HUPS

Samsung CLP-510... | Answered on May 08, 2014


check the drum unit and the transfer belt.

Samsung CLP-510... | Answered on Feb 13, 2014

Not finding what you are looking for?
Samsung CLP-510 Laser Printer Logo

283 questions posted

Ask a Question

Usually answered in minutes!

Top Samsung Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Lawrence Singapore

Level 1 Expert

70 Answers

Are you a Samsung Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

CLP Samsung

  • CLP Samsung

Most Popular Question

paper getting wrinkled as comes printer

  • Office Equipment & Supplies
Loading...