20 Most Recent
Questions & Answers
Summit washer/dryer combo quit drying. Repairman
summit washers are prone to board failures i would say that is where the fault lies . thermafuse fuse means it has been overheating. means it can damage other parts. thermostat would thing that has just worn out thermostat can go if the unit overheats. under line is an electrical fault. but like i've said it is a common fault with this make and others. the main boards can only handle around 50c in temp after that they start to over heat and cause problems. the faults started when they moved the main board from the bottom to the middle.
on Oct 25, 2013
Washer is only filling with hot water washer has been sitting for a few years.
i don't know. check to see if cold water is availabe. shut off hot and cold supply taps. start washer to try to reduced pressure on rubber hoses. shut off washer and disconnect it from hydro. undo cold water rubber hose at the washer. point it into a pail or sink and slowly open supply tap to see if water flows freely. if no water, clean or replace both hoses as they deteriorate with age. if water
runs freely, i think you may have to replace the intake valve on the washer. they usually are easy to disconnect and replace.
10 hours ago
Not finding what you are looking for?