20 Most Recent LG 24 in. LDS 5811 Built-in Dishwasher Questions & Answers


HEATING (ELEMENT) ERROR // Water heating error
The manufacturer has assigned this error or fault code to indicate a problem with the water heating circuit. Turn off the circuit breaker to the dishwasher for 30 minutes, allowing time for the appliance to cool; then restart the cycle. If error returns, check the heating element for continuity and check the wiring harness for any obvious signs of damage. If the heating element shows infinite resistance after testing with an Ohm meter, replace it.

LG 24 in. LDS... | Answered on Oct 01, 2017


Washers do not have a thermal fuse that is dryers. More than likely the washer control panel is defective, have a tech come out and confirm that.

LG 24 in. LDS... | Answered on Jul 10, 2017


Please look one more time. The LG LDS 5811 dishwasher error codes are:

IE Error
OE Error
FE Error
E1 Error
HE Error
tE Error

It would also be helpful to know what happens when this error code displays. Please post back here, OK?

Thanks.

LG 24 in. LDS... | Answered on Jan 10, 2017


This is a heater error. The cause is either a bad heating element or bad thermistor (the thermistor is part of the heater assembly). The heater assembly will need to be replaced.

LG 24 in. LDS... | Answered on Sep 29, 2015


If you can get hold of some tools pop the panel off and check that the cable is still connected to the control circuit board. If it is then it is possible that the cable or the card is faulty.

LG 24 in. LDS... | Answered on Feb 02, 2015


The LE error or fault code indicates that the washer motor is either overheating or has lost connection to the motor control circuit board. Turn off the machine for 30 minutes to let the motor cool down. Then, restart the washer. If the code comes back immediately the motor is not likely to be at fault and so you should check the wiring from the motor to the motor control board. Also, check the wiring and condition of the rotor position sensor, also called a HALL sensor. If the code doesn't come back on immediately, but returns after the washer has run for a while, the motor stator may be defective.

LG 24 in. LDS... | Answered on Oct 12, 2014


The door switch, or switches, are sometimes called interlock switches. The door switch prevents the dishwasher from running while the door is open. If the dishwasher won't start, the switch or switches might be defective. To access the door switches, remove the control panel or inside door panel - depending on the model. They can be tested for continuity.

LG 24 in. LDS... | Answered on Sep 28, 2014


If you can access the bottom of you dishwasher it is as simple as disconnecting the old one and putting new one in. Usually held on with a clip of some sort to the drain pump.

LG 24 in. LDS... | Answered on Sep 02, 2014


You will need to UNPLUG DISH WASHER remove screws that are on inside of door the board is between the inside of the door and the outside of door. Unplug connectors on old board install new board reconnect and put door back togather

LG 24 in. LDS... | Answered on Aug 10, 2014


Check all sensors / latches on the door and frame. If they are not aligned or if there is any debris this could cause the dishwasher to not start but to still have power.

LG 24 in. LDS... | Answered on Jun 30, 2014


YES! Type in "Sears Parts Direct" into your computer, list the whole model number, ( you are missing a couple numbers on the end ) and you will see all the parts and the manual, etc.
Be blessed.

LG 24 in. LDS... | Answered on Jun 24, 2014


Yes this certainly is a sticking point, the inside of the panel is coated with black insulation, when it heats up the wires stick in it and eventually the wires break. The fix is as stated, splice the broken wires together, as well take some of the white insulation and put it in between the wires and the liner.

The errors that can arise from the sticky wires are numerous, LE, IE, etc. EI though is more than likely a siphoning problem. If your unit is noisey during operation, open the door, what is the water level? It should be at the second rim. If not, that is your first clue that the unit is siphoning. Make sure you have your loop in the drain hose.
Sgt 48

LG 24 in. LDS... | Answered on Apr 12, 2014


Simply click on the following link which will take you to the PDF downloadable users manual.
http://kitchen.manualsonline.com/ex/product/headline/m/lg/d/dishwasher/p/LD-2050SH

LG 24 in. LDS... | Answered on Jan 20, 2014


You can download Whirlpool manuals and parts lists here

You can order Whirlpool parts from the Pros here.

LG 24 in. LDS... | Answered on Jan 20, 2014


http://lgdishwasher.yolasite.com/ WE SHOULD CALL THEM "FIX OR REPAIR DAILY'S"

LG 24 in. LDS... | Answered on Jan 18, 2014

Not finding what you are looking for?
LG 24 in. LDS 5811 Built-in Dishwasher Logo

262 questions posted

Ask a Question

Usually answered in minutes!

Top LG Dishwashers Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Mike

Level 3 Expert

4359 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Are you a LG Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

LG Dishwashers

  • LG Dishwashers

Most Popular Question

need user manual lg intello dishwasher

  • Dishwashers
Loading...