20 Most Recent Hitachi 50VG825 50 in. LCD HDTV Questions & Answers


Reseat all connectors that you removed then try once more. its a back light problem reseat back light once more.

Hitachi 50VG825... | Answered on Oct 15, 2012


did you try your av out puts to see if you have sound or you may need to check your audio board or speaker or make sure the setting is right go in to menue an check sound setting

Hitachi 50VG825... | Answered on May 17, 2012


It's possible that the audio section is out but I'd check the cables and the signal first before I got too worried. Then I would check the tv setup to see where/how the input/output is configured. Those will cover about 99.99% of the audio problems you usually see ;-]

The cables could have a short or the connector at the end may be off. The easiest way to check these is substitution. Either hook up the cables to a different tv or hook up different cable to this tv and see if you get sound.

Check the setup menus to see if the audio is looking for a signal or putting out to the correct location.

If it is a actual hardware problem ( I don;t think it is) then you need to get a estimate from a repair shop or the Hitachi repair depot near you.The reason for a estimate is that the repair cost can cost as much as a replacement tv.

Hitachi 50VG825... | Answered on Aug 21, 2010


hello,
First check if the power cable of the television is firmly connected to the main socket, if otherwise open the back cover of the television to check for blown fuses, and otherwise .
well this is common on your model and could be a few different things. one is the video circuit and a cost would range around 100.00. the other is a weak picture tube this would cost more than the TV . sometimes when it is the tube we can adjust it but it does not always last long. sounds to me it would be better to invest into a newer TV in this case.
Hope this help....
good luck :)
let me know if you need more info??

Hitachi 50VG825... | Answered on Jun 02, 2010


sounds like you have your closed caption turned on check that in your menu

Hitachi 50VG825... | Answered on Dec 04, 2009


my samsung lcd 40 inches.power on blink contineoisly when we switch on LCD KIND GIVE SUGESTIONS
THANK U
BAKSHI
vkb3@rediffmail.com

Hitachi 50VG825... | Answered on Nov 14, 2009


You will need a new optic block assembley. This has been a common problem found in all brands of LCD projection type television sets.

Cause for this is fine dust and particles gets "cooked" onto special lenses and even on individual lcd panels. I haven't found a way to clean each optic peices back to original. I usually find the colored filters in most of them had changed to a brownish, hence blocking that color from getting through, leaving a pink, or bluish spot like hue, or even in some cases a starfeild like patern.

Only thing can be done is to search the Internet for a new or refurbished optic block assembly to your make and model.

In the shop I work for, I've seen literally hundreds of these sets, all brand who makes LCD projections, develop this kind of problem. I've exchanged optic blocks on everyone I've gotten since 2001 - 2002 and so far never seen one comming back with same problem twice.

If you are good with following instructions, then it maybe cheaper for you to purchase a service manual with all the parts blow up, access to "Service Man Mode" with all adjustment codes, then purchasing a new or rebuilt optic block assembly... (Some manufacturers will send you a different optic block assembly of wich you must enter the Service Man Mode (SSM), for making proper adjustments per advice from their techs).

Changing one can be a real chore, so it maybe in your favor to higher a competent tech who can do the job right at a good price. If you can't find a personal tech, then shop will be next in line, however it maybe a little expensive.

Hitachi 50VG825... | Answered on Apr 22, 2009


Sounds like your lamp is blown . Replacement part is UX21516 lamp. this is a common problem with my 50VG825 also, 3 lamps in less than 3 years. Try this if you have'nt already. Hope I helped

B.Crowell

Hitachi 50VG825... | Answered on Apr 21, 2009


Ok, so it could be both then. Um if u open up the monitor, then u should see a small chip at the bottom of the lcd. This is called the Inverter. You might have to replace that. I would take it down to any local computer shop, they usually have tools to test it, and see if its broken. unles u just wana replace it, i think they average around 40$ u can simply unplug the old one, and plug a new one in, but it wont be 100% guarantied that. could be a bad installation of your new lamp aswel.

Hitachi 50VG825... | Answered on Dec 23, 2008


My mom and dad had this problem, after replacing the bulb everything is working great again.

Hitachi 50VG825... | Answered on Dec 08, 2008


Replace the main board. Parts on eBay or internet.

Hitachi... | Answered on Sep 02, 2019


Check if there is a reset button on the back or located by the power button on your tv

hope this helps

Hitachi... | Answered on Aug 23, 2019

Not finding what you are looking for?
Hitachi 50VG825 50 in. LCD HDTV Logo

Popular Tags

28 questions posted

Ask a Question

Usually answered in minutes!

Top Hitachi Televison & Video Experts

Jaime Hernandez

Level 3 Expert

2337 Answers

The Knight
The Knight

Level 3 Expert

76115 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Are you a Hitachi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hitachi Televison & Video

  • Hitachi Televison & Video

Most Popular Question

perfect screen

  • Televison & Video
Loading...