Top 20 Canon PIXMA MP830 All-In-One InkJet Printer Questions & Answers


Hi . That problem is the print head. Is defective. Buy a continuous ink system printer. Is more efficient

Canon PIXMA... | 83 views | 0 helpful votes


Either a power supply fault or there is a fault in the main circuit board. You may find a replacement power unit (they are held in by two clips ) at an electronics recycler or auction site like e-bay, but the main board is not an available part.

Canon PIXMA... | 93 views | 0 helpful votes


hi Jackelle21.
i have had a look around the internet and all i can find out from going into forums is that the problem might be because you need to download what they are calling (mp navigator)
so not sure if this is what you have to do.but if you go to this link you will see download sites to where you can get it.



mp navigator download Google Search
or this one.
Canon MP Navigator EX

Canon PIXMA... | 84 views | 0 helpful votes


Did it finish maintenance before you reboot?

Canon PIXMA... | 47 views | 0 helpful votes


The most common cause of this is a failure in one of four earth circuit in the print head. It is not repairable

Canon PIXMA... | 76 views | 0 helpful votes


hi deborah.
see if this link helps you find out why it will not turn on.
Mp 380 printer will not turn on Google Search

Canon PIXMA... | 51 views | 0 helpful votes


Did you let the camera format the sd card before you took your pictures? Have you tried another sd card? Its possible the pc did not close the card properly so the printer does not see it. I would try another card before going any further. Make sure your setting on the printer is set to read only (in "Other" settings) if at read/write you will not be able to print.

Canon PIXMA... | 191 views | 0 helpful votes


Look through your fax machine instructions,. There should be some there regarding how many rings before pickup. Or maybe the unit does not have that feature and is designed to have its own separate line for faxes.

Canon PIXMA... | 54 views | 0 helpful votes


Uninstall the printer driver completely, then reinstall the driver again.

Canon PIXMA... | 102 views | 0 helpful votes


You can sometimes buy cleaning cartridges that contain fluid designed to clean nozzles. See if they exist for your model.

Canon PIXMA... | 274 views | 0 helpful votes


Check for the switch is it not jermed or check the switch contact is it not normally opened or normally closed for the full time.

Canon PIXMA... | 235 views | 0 helpful votes


Hi. Have you try sending fax to other number maybe the problem is the receiver in the other side of the line .

Canon PIXMA... | 57 views | 0 helpful votes


With the machine powered on, open the top cover (including the scanner unit). The cartridge carriage and printhead will move to the center. locate the cartridge needing to be replaced (flashing light or light off) push the clip at the front top corner forward and the cartridge will pop up slightly. Remove and replace. To replace a cartridge remove any nozzle clips and the airway seal tape. Slide the new cartridge into the appropriate slot angling slightly down the in. press down until it clicks in place. If it feels difficult , try again - don't force it. When done, close the cover down and your machine should do a self clean and go.

Canon PIXMA... | 56 views | 0 helpful votes


Try unplugging from your computer, uninstall printer on your computer and reinstall.

Add or remove printer

Canon PIXMA... | 71 views | 1 helpful votes


The print head needs cleaning. You can watch a you tube video on how to do it.
CANON PRINT HEAD CLEANING VIDEO

Canon PIXMA... | 59 views | 0 helpful votes


scanners/ printers costs are as low as $35.00 for a new one and if it is a wifi unit may be $100.00 to replace new
with labor costs and parts ( if you can get them) I would consider junking it and get an updated new one

Canon PIXMA... | 66 views | 1 helpful votes


The 5010 error indicates a scanner error. The scanner unit cannot detect the home position, or the scanner unit warming-up is not done properly at power-on. On the LCD, "Scanner is not operating correctly." is displayed.
The 6100 error indicates a logic board error. The check sum value is incorrect in the ROM check at hard-power-on.
Fixing these errors is more expensive than replacing the printer. Sorry.
Fixing F

Canon PIXMA... | 230 views | 0 helpful votes


If you have tried cleaning the nozzles as Oliver suggested. Try setting your paper type to 'high resolution' and try printing. If this works, your circuit board is probably the problem and you need to replace the printer after using up your inks in the 'high resolution paper' print mode

Canon PIXMA... | 304 views | 1 helpful votes

Not finding what you are looking for?
Canon PIXMA MP830 All-In-One InkJet Printer Logo

1,992 questions posted

Ask a Question

Usually answered in minutes!

Top Canon Office Equipment & Supplies Experts

Clive
Clive

Level 3 Expert

4345 Answers

old marine
old marine

Level 3 Expert

2256 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

PIXMA Canon

  • PIXMA Canon

Most Popular Question

get canon pixma mp830 printer print

  • Office Equipment & Supplies
Loading...