20 Most Recent Canon ImageClass D880 Copier Questions & Answers


Clean the Scanner Glass well (there should be signs or some dirt) and the problem will be solved!

Canon ImageClass... | Answered on Aug 24, 2013


Lift the document feeder and clean the narrow glass, (next to the glass where you place your originals). Documents are scanned across this glass when automatic feeder is used, thus a small piece of dirt becomes a line down the page.

Canon ImageClass... | Answered on Aug 15, 2013


i think power card OR mother board problem

Canon ImageClass... | Answered on Feb 26, 2013


Here's the definitive reset. It will work on the following models: ImageRunner 1200/1300, PC1060/1061/1080F, ImageClass D620/D660/D661/D680/D681
Press Additional Functions key
Press #
Press > to #7 Printer Function
Press Set
Press > to #4 Printer Reset
Press Set
Press <
Unplug printer and repower it.

Canon ImageClass... | Answered on Aug 07, 2012


Hello.Have a look at your paper first.it could be foged or damped.Otherwise you will need to replace the Hot roller, pressure roller , thermoster and bushes

Canon ImageClass... | Answered on Jun 14, 2011


I was ever have that problem.
the solution is I moving slide the scanner section more hard then usually.
and I think that is the lock of scanner not fit.

Canon ImageClass... | Answered on Jun 01, 2011


assure the replace of paper cassete.
if still like that.
remove the paper cassete
find the sensor cassete in side
and you clean up.

Canon ImageClass... | Answered on May 14, 2011


additional functions # to enter diags. do #7 printer reset. if it comes back fuser needs replaced. i have them and they are serial # specific
thetech@clearwire.net

Canon ImageClass... | Answered on Mar 07, 2011


Not many as I use them for all of my service customers. They key is using a good source for the cartridges. There are cartridge "remanufacturers" who will sometimes just refill the toner chamber and do nothing else to the cartridge. This is where people run into problems and develop a bad attitude towards remanufactured cartridges. A proper remanufactured cartridge will have a new drum, wiper blade, seal etc. installed EVERY time thus making it a much more dependable unit. On your machine what I recommend is check with local cartridge suppliers if available and get a cartridge there. Then once you open it up and before you pull the seal tape out of it, turn it over and slide open the drum protection "gate" and look at the drum. It should be clean, shiny and obviously look like new. If it has wear lines or any other obvious signs of wear then return it and show them that this cartridge has an old drum. I would not give them a second chance.
If you need an online vendor than I would suggest PrecisionRoller.com
They have your cartridge for $39.00 and their part number is V3920.
I have had very good luck with all of the cartridges I get from them. They also offer free shipping on an order of just $75 or more.
Good Luck and Thank You for using Fixya.
WheatlandServices

Canon ImageClass... | Answered on Nov 13, 2010


fuser error replace it they are serial # specific

Canon ImageClass... | Answered on Nov 12, 2010


hi; its a fusing unit problem check the heater it can be a bad contact

Canon ImageClass... | Answered on Oct 20, 2010


Here's the definitive reset. It will work on the following models: ImageRunner 1200/1300/1310,1330,1370,1630,1670, PC1060/1061/1080F, ImageClass D620/D660/D661/D680/D681/D880

Press Additional Functions key
Press #
Press > to #7 Printer Function
Press Set
Press > to #4 Printer Reset
Press Set
Press Unplug printer and repower it.

Canon ImageClass... | Answered on Oct 11, 2010


if you found a spring from the fuser and a flat blade like piece of black plastic this would be a detach finger and tension spring all fusers have the they help prevent the paper from rolling up on the fuser roller. fusers have either 5 or 6 depending on the model.they will funtion muinus one of these. if you get regular paper jams in the fuser of if they start replace fuser

Canon ImageClass... | Answered on Oct 04, 2010


Did you get a label stuck on it???? I would say you are going to have to replace the cartridge. The damage is done.....

Canon ImageClass... | Answered on Sep 22, 2010


TASK ALFA 521 I THE BETTER

Canon ImageClass... | Answered on Sep 01, 2010

Not finding what you are looking for?
Canon ImageClass D880 Copier Logo

86 questions posted

Ask a Question

Usually answered in minutes!

Top Canon Office Equipment & Supplies Experts

Clive
Clive

Level 3 Expert

4345 Answers

old marine
old marine

Level 3 Expert

2254 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Canon Office Equipment & Supplies

  • Canon Office Equipment & Supplies

Most Popular Question

error code e003 fix myself

  • Office Equipment & Supplies
Loading...