20 Most Recent Galaxy Radios DX- 88HL Base CB Radio Questions & Answers


well don't use it on those bands

Galaxy Radios... | Answered 3 days ago


RUSHING SOUND ?
1. Get the noise then disconnect the coax and see if noise goes away on receive, if noise goes away then address the ground on your antenna,
if noise still there then address the ground wire from power source

Galaxy Radios... | Answered on Jun 29, 2019


sounds to me like a bad PLL chip. but then again, I'm no Master tech myself.

Galaxy Radios... | Answered on May 18, 2018


Hi,

If the antenna for the other properly operating radio is used with the radio with the noise and you are getting the static then we can assume it is the radio. If you hear signals with the static, that is, it does receive communications at the same time, there may be a problem with the noise reduction circuitry, or a defective component(s) in the receiver. Without knowing your experience I would suggest taking to a radio shop.

Galaxy Radios... | Answered on Mar 03, 2017


  • Is it drifting off frequency by the radios meter or an external meter. If its the radios meter then hook up a meter externally.

Galaxy Radios... | Answered on Sep 27, 2016


adjust the hi and low power on side band ,also make sure you have good SWR match.

Galaxy Radios... | Answered on Mar 16, 2015


take it to a tech and let them earn their money.

Galaxy Radios... | Answered on Mar 16, 2015


on the face plate is a button for the counter ,try pushing it several times to see if the dot moves. As long as the channel display is reading the correct channel you should be ok but you want to correct this problem . If you can't correct it contact Galaxy and they will have a tech talk to you.

Galaxy Radios... | Answered on Mar 16, 2015


I'm not going to be corrected on this as i'm tempted to say A or C and sometime D. Instead i would say switch channel to 19 then watch frequency counter as you change band selector until you find 27.185 and you have arrived.

Galaxy Radios... | Answered on Mar 04, 2015


try the original mic . If its still distorted then it,s a radio problem.

Galaxy Radios... | Answered on Jan 12, 2015


in order to do this you will need a scope,an rf signal generator and an AF vtvm also a dummy load. These are the pods you wanted to know about. They must be done in order so here goes L8 to max then L7,9,11,12,13,52,3,4,5 now go back to L8 and make sure you are still at max on scope Then set vr1 and 4 .go to L14 and 15 .Now go to vr 2 and 3 .now to L1 and 2 check for overall with L6 . This is a brief reading of what you do to get what you are looking for.If you still want to do it or have a tech do it then go to www.cbtricks.com . Look up the letter P the search for president then Grant XL click on it and follow the directions for a receive alignment.

Galaxy Radios... | Answered on Jan 12, 2015


tryadding a 470k ohm resister from the junction of c154/r207 to the junction of C-187 / R-235 on the solder side of the board.

Galaxy Radios... | Answered on Dec 17, 2014


turn the talkback knob to the right and push it in to engage talkback.when you get the volume you want leave it alone .Now key the mic.You will probably hear a squeal coming from the speaker.Now turn the volume down on the talkback knob until the squeal goes away.If you run your RF gain wide open it may squeal also.

Galaxy Radios... | Answered on Nov 29, 2014


could be a lot of things. How your S.W.R. if its bad your radio is not performing properly. you could have a final problem. Check the voltage going to the audio IC. Do you have a service manual,you're going to need one.If you don't want to go through the process of elimination then maybe you should take it to a tech.

Galaxy Radios... | Answered on Nov 29, 2014


wire it to what type of mike?

Galaxy Radios... | Answered on Sep 11, 2014


you cannot do it .Take it to a tech,they will have the proper equipment and knowledge to do it.

Galaxy Radios... | Answered on Sep 01, 2014


if you hooked it up its wrong but I assume you didn't.First of all talkback is a feature that allows you to hear your voiceand you don't5 need a radio check because you can tell by your own voice how your radio sounds if you want it to work on am you need to attach a 33ohm resistor from the positive to the neg of the external and pa plug ins. the talkback will be on all the time by the way.

Galaxy Radios... | Answered on Aug 09, 2014


27.185

Galaxy Radios... | Answered on Aug 09, 2014

Not finding what you are looking for?
Galaxy Radios DX- 88HL Base CB Radio Logo

103 questions posted

Ask a Question

Usually answered in minutes!

Top Galaxy Radios Radio Communications Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Brad Brown

Level 3 Expert

18108 Answers

Mike Charette

Level 3 Expert

1847 Answers

Are you a Galaxy Radios Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Galaxy Radios Radio Communications

  • Galaxy Radios Radio Communications

Most Popular Question

wire rk56 microphone galaxy cb radio

  • Radio Communications
Loading...