20 Most Recent HP LaserJet 3600n Printer - Page 2 Questions & Answers


59.C0 ERROR
An error occurred with the developing separation-drive assembly.
1.Check that the following connectors on the driver PCA are seated correctly: J403, J405, J213.
2.Check that connector J1020 on the DC controller is seated correctly.
3.Check that connector J5008 on the fuser motor is seated correctly.
4.Replace the developing separation-drive assembly.
5.Replace the memory-controller PCA.
6.Replace the fuser.

HP LaserJet... | Answered on Jun 28, 2014


I have a same problem, Did you find a solution?

HP LaserJet... | Answered on Jun 13, 2014


Hope you are doing well and sorry that you are having this issue;
The troubleshooting steps in this link may help;
Resolving Print Quality Issues

Hope It's resolve all Your Printer Problem,
Or Still having Problem Then follow Us For HP Support

HP LaserJet... | Answered on Apr 22, 2014


I tried the reset fuser and your instructions do not work for the 3600n. reset supplies is under another category and new fuser kit is not an option?????

HP LaserJet... | Answered on Feb 06, 2014


immediatly below the fuser unit/ above the image transfer belt inside the covers are the colour calibration sensors- they have mylar windows which get coated over time- clean with isopropyl- the sensors are looking vertically down and are approx 5x15mm is size there is one sensor to the left and one to the right, if after cleaning these the error still exists- try replacing the ITB and try again

HP LaserJet... | Answered on Jan 30, 2014


59.xx error main motor failed to reach rotation speed in a given time:-
have you recently changed a toner cartridge? is it 3rd party?
remove all toner cartridges and then switch power on to printer - it should turn over then ask for toners to be inserted, if so the problem probably lies with a toner cartridge
if the toners prove to be ok then the issue may be the Developer lift plates ( front/rear) which tend to snap after a while not an expensive repair but time consuming..fuser units on this machine dont generally give main motor failures neither does the transfer belt. If I was attending this call I would definatly have a full set of spare toners and the dev lift plates to hand as this would most likely be the fix

HP LaserJet... | Answered on Jan 17, 2014


This is probably because of a defect or missing RAM chip. Try replace the RAM chip on formatter board or call for service if the product is still under warranty. Check for yourself HERE.

Good luck.

HP LaserJet... | Answered on Nov 18, 2013


Problem with print cartridge

HP LaserJet... | Answered on Oct 18, 2013

Not finding what you are looking for?
HP LaserJet 3600n Printer Logo

392 questions posted

Ask a Question

Usually answered in minutes!

Top HP Office Equipment & Supplies Experts

Clive
Clive

Level 3 Expert

4345 Answers

Ekse

Level 3 Expert

13434 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Are you a HP Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

LaserJet HP

  • LaserJet HP

Most Popular Question

hp3600n makes grinding sound start

  • Office Equipment & Supplies
Loading...