20 Most Recent Kenmore Freezer 20.3 cu. ft. Frost Free Upright Freezer Questions & Answers


It sounds like the compressor is locked (seized). The current overload is doing it's job by opening the circuit. Take a current reading, on the common leg, while the compressor is trying to start. The locked rotor amps (LRA) for that compressor will be indicated on the compressor tag. If it's drawing LRA while trying to start, you need a new compressor. Which is the costliest part in that unit and requires specialty tools to replace.

Kenmore Freezer... | Answered on Apr 26, 2017


Door seals are leaking air into the cabinet.

Kenmore Freezer... | Answered on Apr 04, 2016


no, need more info, model serial and do you hear anything at all.

Kenmore Freezer... | Answered on Mar 10, 2016


check the RepairClinic site, as they indicate what may be wrong when there is a 'rattling' noise in a freezer

Kenmore Freezer... | Answered on Jan 17, 2016


Probably needs to be vacuumed and a little oil, if that doesn't help the fan may need to be replaced

Kenmore Freezer... | Answered on Oct 10, 2015


Logically it would be warmer. Up = higher temp; down = lower

Kenmore Freezer... | Answered on Sep 25, 2015


One reason for the fan running is that it is trying to distribute the air in the compartment. Look at the very rear of the freezer on the bottom and see if the little vents, which allow water to disperse, are not filled with frozen ice. If so, turn off the fridge (unplug it) and use a hair dryer to melt that ice until it is all gone. That will probably fill the condensation pan under the unit and you'll need to empty it.

Kenmore Freezer... | Answered on Jan 27, 2015


Sounds like the thermostatic control is worn out. Replacing it should fix the problem.
Hope this helps.
Bob

Kenmore Freezer... | Answered on Dec 17, 2014


I think problem its not with thetmostat but the compresor work but not correctly not have enought power to create pressure.

Kenmore Freezer... | Answered on Nov 26, 2014


Try clearing all vents - inside (make sure vents not covered - in fridge and freezer) and outside (gently vacuum - the coil areas in the back and bottom of fridge)
Air needs to circulate in both parts (dependent on eachother)

Kenmore Freezer... | Answered on Sep 21, 2014


check and empty the drain pan, you should be able to gain access by removing the vent grill below the door if there is one. The pan is under the unit somewhere. There is also a drain tube, make sure its not blocked with ice.

Kenmore Freezer... | Answered on Sep 06, 2014


Is the compressor relay bad?

Kenmore Freezer... | Answered on Aug 28, 2014


A Torx bit for a power screwdriver or a Torx wrench size T20 or T15 probably.

Kenmore Freezer... | Answered on Aug 05, 2014

Not finding what you are looking for?
Freezers Logo

295 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Freezers Experts

Jay Finke
Jay Finke

Level 3 Expert

1389 Answers

geapptech

Level 2 Expert

157 Answers

Felizardo Erilla
Felizardo Erilla

Level 2 Expert

241 Answers

Are you a Kenmore Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kenmore Freezers

  • Kenmore Freezers

Most Popular Question

chills properly but when fan turns makes

  • Freezers
Loading...