20 Most Recent Danby DWC283BLS Wine Cooler - Page 7 Questions & Answers


that's always a possibility but not always the case. The thermostat may not be cycling correctly or set wrong. The condenser could be dirty or if there is a fan, it may not be running. Freeze ups can also cause an "Out of temp." condition. Check it out.

Danby DWC283BLS... | Answered on Apr 15, 2010


ck tsta setting maybe move tsta thermal coupler to diff spot

Danby DWC283BLS... | Answered on Apr 11, 2010


Bad relay or compressor.

Danby DWC283BLS... | Answered on Apr 08, 2010


it may also be a blockage so look for a R/A engineer to check for both leakage and blockage.

Danby DWC283BLS... | Answered on Feb 27, 2010


you must try from insyde, all my model's have acces from inside. you dont have a seal, remove carrefuly to not bent somethig and it will be ok. I presume that fan is an tangetial fan (that kind of fan have all my wine cooler's) you will need a screwdriver phillips and maybe a wrench.

Danby DWC283BLS... | Answered on Feb 21, 2010


the mildewing is becouse its to damp there and it needs a lot more air to shift this damp away,,,i found the best thing to get rid of mildew is to wash every thing down using a strong mix of white vinegar,,, it works realy well on the inside of wooden boats??
its cheep too, it just smells like a chip shop for a day or so but it will work

Danby DWC283BLS... | Answered on Feb 19, 2010


Could be a defective thermostat, or you could have placed your cooler in a area without adequate ventilation.

Danby DWC283BLS... | Answered on Feb 04, 2010


Hi,

Hold ON. This is a Common Error on these Wine Coolers. As Per Danby, they do mention it is a " Sensor " Problem but

Danby DWC283BLS... | Answered on Jan 01, 2010


Hi



Thanks for using FixYa. To reset the unit you’ll need to switch it off, unplug the switch from the power socket and mains and let it off at least 8-10 hours to resolve the issue. If still the issue persists and as you are able to hear the compressor and fan working you’ll need to check that there is no leakage in the system. The top fan will only function when it’s too cold and the heater is in on position.

Please do accept the solution if the issue is resolved or else revert for further assistance.


Thanks

Rylee

Danby DWC283BLS... | Answered on Dec 22, 2009


the top fan is not suppose to run all thetime only when its too cold and the heater kicks then the top fan will come on,you probley have a leak in the system

Danby DWC283BLS... | Answered on Nov 13, 2009


No,you have a leak in the system.

Danby DWC283BLS... | Answered on Nov 13, 2009


not worth repairing , get new

Danby DWC283BLS... | Answered on Aug 23, 2009


The compressor needs to be tested to see if it's operational. This normally needs to be done by a service tec.

Danby DWC283BLS... | Answered on Aug 21, 2009


Disconnect the power cord from the wall outlet and wait 30 minutes before pluging back in. This should clear all settings on the cooler.

http://www.danby.ca/cms/uploads/products/en_manual/DWC283BLS.pdf

Danby DWC283BLS... | Answered on Aug 07, 2009


The problem is likely with one of the two fans. A new fan is available from Danby (1-800-263-2629). My noisy fan is the condensor fan located at the bottom rear of the device. After removing the cooler from under the cabinet, the source of the noise was obvious. You will need to tell them whether it is the upper fan or lower fan. Leave the cooler upright for a few hours before you plug it in so that you do not damage the condenser. Price for the fan from Danby is $20.15 including shipping. Users Manual is available at http://www.danby.com/manuals/DWC512BL.pdf -Ron

Danby DWC283BLS... | Answered on Jun 13, 2009


Hi,

YOU MIGHT HAVE A FAULTY COMPRESSOR (MOTOR) OR A GAS LEAK.LET ME NO IF YOU NEED FUTHER ASSISTANCE ALSO THE VENTALATION COULD CAUSE IT AS YOU SAY THAT IT IS BUILT INTO THE CABINITS SO REMOVE IT

OR

If the motor are running the gas level are too low . if the motor are not running check the thermostat. if there are power by the motor and stil not running then it is the motor

OR

Does the compressor run or shut off when it gets to 55 &57? Leave unplugged over night and try again..

Also a dusty coils could cause the problem . its very important to keep the coils clean

Thank You

Danby DWC283BLS... | Answered on May 31, 2009

Not finding what you are looking for?
Danby DWC283BLS Wine Cooler Logo

243 questions posted

Ask a Question

Usually answered in minutes!

Top Danby Furniture Experts

Dennis Boxerman

Level 3 Expert

1300 Answers

jdthefixer

Level 3 Expert

745 Answers

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Are you a Danby Furniture Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Danby Furniture

  • Danby Furniture

Most Popular Question

danby wine cooler not keeping set

  • Furniture
Loading...