Honeywell ER150B Air Conditioner - Answered Questions & Fixed issues


Hitachi DC Inverter Scroll Compressor have a startup problem. when i start the unit the compressor start a voice of " Tak, Tak , Tak rasie and after 30 Second the compressor trip, after few minutes the compressor again try to start and again Tak, Tak, raise and compressor trip. please somebody help me about this issue.

Honeywell ER150B... | Answered on Aug 25, 2014 | 137 views


probably low on freon. i assume compressor is running?

Honeywell ER150B... | Answered on Jan 25, 2014 | 167 views


Keep heating mode and temp setting at minimum 3 to 4 degree C* between room and required temp.

If still not working, replace the heating sensor.

Tnx

Honeywell ER150B... | Answered on Nov 16, 2013 | 79 views


Check fan/limit control on older unit. newer unit check limit switch

Honeywell ER150B... | Answered on Nov 13, 2013 | 35 views


Hi, if the button has tripped, this is normally due to a problem, as this is a safety. But it may also be that the button its self is faulty if the unit is running properly. You must make sure you have no other problems going on such as high head pressure in system by washing out the condenser coil, checking motors, looking over the electric connections for any signs of burned spots ect. You can just simply take the wiring at the reset button and bypass it to run, but if you have a problem you are unaware of, this will cause a problem. What I would do is write down your model and serial numbers, kill power to unit...., remove this reset and take it to any retail appliance parts house to get one that will take its place. Just about any kind will work if the voltage is correct and amperage, even if it will not fit the hole or not. You can mount it any where inside out of the weather, just make sure you draw a diagram when removing it so you will remember how it goes back. If the new one trips right away, you indeed have a problem in the unit and will need to find it. You can do this by process of elimination to see when it holds when you disconnect a componant. Please rate me on my help to you, and I will help you until the problem is solved.
Shastalaker7
A/C, & Heating Contractor

Honeywell ER150B... | Answered on Aug 28, 2011 | 39 views


Sounds like you have a problem with the indoor blower inside that cab. hope this helps.

Honeywell ER150B... | Answered on Aug 13, 2011 | 218 views


Myself download and checked. Go with:

www.honeywellparts.com/honeywell-er150b-parts.html

Helpful?

Honeywell ER150B... | Answered on Jan 06, 2011 | 44 views


i would ask around to friends and family first to see if they have had a good experience with someone. Usually the one that advertises the most is not the honest company..

Honeywell ER150B... | Answered on Aug 20, 2010 | 31 views


Hi,

Here is a tip about troubleshooting your air conditioner...
There are many things that can cause your air conditioner not to cool…

Air Conditioner Trouble -Review the Possibilities
http://www.fixya.com/support/r3571569-air_conditioner_trouble_review_the_possi

heatman101

Honeywell ER150B... | Answered on Aug 19, 2010 | 88 views


Hi,
You have it right. The number you set is the temperature it will give you.
Higher number, Warmer. Lower number, cooler.
Good Luck,
Wayne

Honeywell ER150B... | Answered on Aug 14, 2010 | 153 views


you should call honeywell , give them model and serial number and they should be able to help you . they would help you with tour manual .

Honeywell ER150B... | Answered on Aug 11, 2010 | 48 views


you need a 15/20 degees split difference from your supply and your return...

Honeywell ER150B... | Answered on Jun 28, 2010 | 78 views


your compressor is not running for some reason setting thermotat to 65 does not make this unit cool any faster

Honeywell ER150B... | Answered on Jul 06, 2014 | 418 views


press "run prgm"....then adjust to what function and temp you want...then press"hold"

Honeywell ER150B... | Answered on May 11, 2010 | 121 views


this unit is an energy recovery unit. Here is manual http://customer.honeywell.com/techlit/pdf/PackedLit/69-1188.pdf

Honeywell ER150B... | Answered on May 10, 2010 | 67 views


Check your air filters and replace if necessary. Check the indoor and outdoor coils and clean if needed. If the line is still is freezing get the refrigerant charge checked.

Honeywell ER150B... | Answered on May 03, 2010 | 175 views


Go to honeywell.com
Under red welcome sign
Bottom red highlighted box literature/image search
Type in thermostat model number
Click on arrow to right
Then click on the PDF files owners manual / installation instructions
If you can’t find what you want, the bottom left and bottom of web
Page, they have homeowners assistance and Home products to get the help you need.

Honeywell ER150B... | Answered on Apr 12, 2010 | 78 views


Sounds as if the compressor has gone bad. The blowing of hot air and then the fuse blowing lets you know the compressor is pulling a lot of amps causing the fuse to blow and no cold air could mean the compressor is locked up and therefore you need a new compressor.

Dave

Honeywell ER150B... | Answered on May 14, 2014 | 243 views

Not finding what you are looking for?
Honeywell ER150B Air Conditioner Logo

Popular Tags

59 questions posted

Ask a Question

Usually answered in minutes!

Top Honeywell Heating & Cooling Experts

Bill Long

Level 3 Expert

606 Answers

Paul Carew

Level 3 Expert

3476 Answers

Cindy Wells

Level 3 Expert

6046 Answers

Are you a Honeywell Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...