20 Most Recent Kenmore 12-Cup Coffee Grinder and Brewer, Stainless Steel - Page 3 Questions & Answers


If the cups are jamming straight after you clear a jam it means one of to things. 1: Non vending or poor quality vending cups are being used. The SG200 is very sensitive to the rim of the vending cup. Make sure the rims are circular are even and have no bits of card board hanging out of the rim.
2: Cup cams are out of alignment. Take all of the cups out of the machine and also take the cup carrousel (cup tubes) off. Look down at the 5 black cup cams and check if they all look in the same position. There is instructions on how to realign the cams on pages 52-53 in the manual that came with the machine. If you need a copy of the manual I'll need a email address the send it to you.

Coffee Makers &... | Answered 2 days ago


Google (cordonbleu)(12086)(manual) without paens OR contact Cordon Bleu directly to request it.

Coffee Makers &... | Answered on Oct 13, 2019


Instant coffee is basically ground coffee that has been freeze-dried, packaged and sold. It is rehydrated by pouring hot water over top. This type of coffee is ideal for travelers or to anyone without a coffee pot/time to wait for their coffee to brew.

Coffee Makers &... | Answered on Oct 10, 2019


Our machine was about two years old when this error appeared. "Add cleaning tablet" was stuck on the screen, and it would not recognize when I added one. I turned it off, and the tablet would drop into the grounds container. An easy fix I found, take a few paper towels and roll them up into a tube. Insert the paper towels down into the cleaning tablet opening (and hold on to it!) and twist it while moving it up and down. Shining a flashlight down in the opening and you will see all the coffee ground residue on the sides of the shoot. The paper towels will knock off all the old coffee grounds stuck down below. Added another cleaning tablet, and voila. Machine cleaned and good as new.

Coffee Makers &... | Answered on Oct 07, 2019


TRY COOKS ESSENTIALS AS FIXYA DOES NOT HAVE ANY PRODUCTS TO SELL ASK GOOGLE OR AMAZON

Coffee Makers &... | Answered on Oct 06, 2019

Tip

Keuring coffee maker B60 B70 B77reservoir full but fails to refill, brewing half-filled cups


After a brief investigations found out that this is a design problem for all the newer Keurings like B60, B70, B77, Keuring factory after a lot of complains of a noisy refill pump this is the pump which pressed water from reservoir tank into the brewer. (Please to mixed it with the second pump that presses the hot water through the K-cup this is a different one).
In the place of that pump now they are using a small DC motor and impeller pump, which is much quieter however the new design just won’t work.
It seems that we have air that gets into the system and the new pump isn’t strong enough just to SELF-PRIME with this way. With this way the motor still runs, runs, runs but water is not going through it and finally it turns itself OFF in order not burn out. Normally it should take only few second to refill the brewer tank.

There were many options that the problem was due to the check valve located in the base of the unit just below the reservoir seats itself. However actually this small new pump cannot press hard enough to open the check valve so the water can easily flow. If there is air in the system or slightly scale this make it harder.

I have found out that that the problem occurs only just a few weeks after we use a brand new machine.
So one very good way to solve the problem is to turn the machine on and lift the water reservoir up just a couple of inches and then jam it back in place fast and hard. With this way is like it injects just enough pressure into the system to open the check valve and when the motor pump will run you will realize that immediately water will passing through from reservoir to brewer tank. This procedure has to be done often between cups.

From what we seen in internet their hundreds about the same problem but we have not see any serious response about it From Keurings customer service yet.
One other important and related problem frequently reported is the irregulars doses of coffee like HALF-FILLED CUPS of coffee e.t.a

This must be redesign from Keuring factory since there is not much we can do about it to solve once for all even if they will replace your machine with a new one you will have the same problem in few weeks. And definitely this not a problem due your Electricity in your area or due to hard water. However hard water areas will face bigger and more intensive the above problem so one more suggestion is to decaling the machine every week this will help a lot.

If you find the above helpful please remeber to vote for it

on Oct 06, 2019 | Coffee Makers & Espresso Machines


If you're getting a "no water" error message then you need to "prime" the machine by either:

1. Fulling the tank with water and leave it in the machine for 2 hours at least.
2. Re-seat the water tank about 70-80 times to get the bubbles out and the water flowing.

Coffee Makers &... | Answered on Oct 05, 2019


Motor overload
Are the paddles jammed
Remove fluid and dislodge paddles if jammed

Coffee Makers &... | Answered on Oct 03, 2019

Not finding what you are looking for?
Kenmore 12-Cup Coffee Grinder and Brewer, Stainless Steel Logo

6 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Coffee Makers & Espresso Machines Experts

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Jude24

Level 3 Expert

313 Answers

gbob59

Level 3 Expert

3042 Answers

Are you a Kenmore Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kenmore Coffee Makers & Espresso...

  • Kenmore Coffee Makers & Espresso...

Most Popular Question

coffee getting stuck in shoot between

  • Coffee Makers & Espresso Machines
Loading...