20 Most Recent
- Page 8 Questions & Answers
I installed a weiser smartcode lockset and the
2 important things which may seem dumb but solved my problem:
- Make sure that once everything is in place, you hold the lock button before inserting battery pack (and keep holding the lock button) until you hear 2 beeps. The latch should come and go.
- Last but not least, make sure you put NEW batteries in... I had old batteries and when i tried it seemed like is was working but could not finish the door direction finding sequence stated above. Make sure they are new and it should work!
on Jul 21, 2015
Dead bolt too stiff
If you mean it feels like it's dragging when extended, it probably need to the screws holding the inside portion of the lock to the outside portion and realign those two while actuating the lock to find where it operates freely.
on Jan 31, 2015
Key pad will not work at all
soak the lock in a container of 90% isopropyl alcohol you can get this at a drugstore for about a dollar a pint then let dry in the sun.
I take these apart and spray the parts with alcohol but only try this if you think you can put the lock back together again correctly
on Nov 18, 2013
I need to reprogram the
First, push the program button on the power board once. Enter the four to eight
digit code by pressing the numbers on the outer touch pad. Press the lock button on the
lock button on the touch pad to set the code. You will hear a two second long beep when
your code is accepted. If the unit does not beep, too much time has elapsed between pressing
the program button and entering the code. Repeat the programming sequence. Enter your number
to check that it works.
on Jul 27, 2011
Not finding what you are looking for?