20 Most Recent Kenmore 38 Bottle Dual-Zone Wine Cellar - Page 7 Questions & Answers

Did you replace every thermostats in the fridge? At minimum there is 2 once for the freezer and 1 for the fridge. It could also be an issue on the power board thats killing you control boards. Idk but it would be smart to build the unit so that even with a temperature sensor failure it would operate on a time base operation rather then constant ruin which is never advise so its best to assume that you have a power problem somewhere. Good Luck

Kenmore... | Answered on Jan 31, 2019

Most Kenmore model #s have a 3 number prefix followed by a dot and then 8 more numbers

Kenmore... | Answered on Jan 28, 2019

At least 8 years old.

Kenmore... | Answered on Jan 27, 2019

It there are no trim pieces covering screws, Pull up hard and fast on handle to remove it. Then tighten posts that handle attaches to

Kenmore... | Answered on Jan 18, 2019

Searspartsdirect.com or call Whirlpool Corp

Kenmore... | Answered on Jan 09, 2019

This is caused by air leaking past the seal in the shut door. Push in on the paddle and release and watch the door shut close. It should make an air tight seal. You can also shine a flashlight in the shut and look at the opposite side to look for light.

Kenmore... | Answered on Jan 04, 2019

Check these things.
Is the fan running in the freezer?
It should be running when the refrigerator is running.
Is there ice or frost on the back wall inside the freezer?
It should have none. If iced up your air flow is being blocked to the refrigerator section. Something is wrong with the defrost system.
Are your controls for the freezer set in the middle of the dial?
If its all the way up as cold as it can go you are actually slowing the airflow to the refrigerator. It should be in the middle. The refrigerator control can be set higher.
Is the fan under the refrigerator running when the compressor is on?
If not you may have a bad condenser motor.
You mentioned a noise when the unit shuts off, if its the fan by the compressor clear whatever is hitting the blade. If it in the compressor it is not repairable without replacing the compressor. However it should not affect the cooling of the refrigerator. The banging noise is caused by a broken suspension spring inside the compressor. so when it shuts off the compressor bangs against the housing. By the way your refrigerator was built by GE for Sears Kenmore

Kenmore... | Answered on Jan 04, 2019

open the freezer door and empty the shelves look at the bottom of the panel in the freezer where the air holes are if it frozen or iced up. thats your problem your air flow is blocked with ice. other possibility would be a fan failure.

Kenmore... | Answered on Jan 04, 2019

If you've been using it for awhile it'll most likely be what's called 'scaling' or calcium/magnesium deposits...which means you have what is called 'hard' water with a high mineral content.
Water softeners will help reduce this issue.

Kenmore... | Answered on Jan 04, 2019

Length x width x height inside measurements

Kenmore... | Answered on Dec 30, 2018

The bulb cover should just snap in place. Use a butter knife or putty knife to slide in at the edge and pop it out.

Kenmore... | Answered on Dec 23, 2018

Not finding what you are looking for?
Kenmore 38 Bottle Dual-Zone Wine Cellar Logo

2 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Refrigerators Experts

Fred Sops

Level 2 Expert

351 Answers

Audrey Messer
Audrey Messer

Level 2 Expert

182 Answers


Level 2 Expert

55 Answers

Are you a Kenmore Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kenmore Refrigerators

  • Kenmore Refrigerators

Most Popular Question

cause leak water

  • Refrigerators