Kenmore 38 Bottle Dual-Zone Wine Cellar - Answered Questions & Fixed issues
What would cause it to leak water?
all refrigerators will make condensation it is were evaporator meets air takes moisture out drips down into a pan located on or near compressor it maybe as simple as a plastic hose out of collector pan that will have on some refrigerators a fan .
heat from compressor and fan will evaporate the water.
your problem also can be bad door gaskets letting humid air into it
Check door gaskets make sure it seals check drain pan may have a rust hole or its plastic and may have a crack in it
send us a model # we can tell you were to look
on Jul 02, 2015
Kenmore 795 leaking water behind ice maker
I would first check the hose that brings the water from the pipes in the house up into the icemaker make sure that's not leaking. Then I would check all of your connections, Making sure they are good and tight and that there's no holes either in the copper line or the poly plastic line. If all of that checks out fine and you have no leaks there then I would investigate the icemaker.
on Aug 24, 2019
Where is the temperature control located for kenmore coldspot refrigerator model 106.51139210
There are two temperature sensors (one in the refrigerator and one in the freezer). The refrigerator sensor is near the front of the compartment on the right side below the door switch and above the slides for the drawers. The freezer's refrigerator temperature sensor is on the left near the top of the compartment. See the two liner diagrams on the page linked below. To change the temperature, press and hold the Temperature button on the LCD panel for 3 seconds. The display should read the current temperature set point and Refrigerator. Use the Acceler-Ice button to lower the temperature in the fridge. Press the Lock button to raise the temperature in the refrigerator compartment. Press Temperature again to see the Freezer set-point and adjust it as above. Note: the temperature in each part of the unit depends on air circulating from the freezer into the refrigerator. Make sure that the vents aren't blocked. Wait 24 hours after adjusting the temperature set points for the unit to reach equilibrium before deciding if the set point should be adjusted further.
Sears Parts Direct has the parts diagrams for the 106.51139210 here: https://www.searspartsdirect.com/model/4lfq9qfxpx-000582/kenmore-10651139210-side-by-side-refrigerator-parts
. This page also has a link to the owner's manual for the side-by-side refrigerator, https://c.searspartsdirect.com/mmh/pd_download/lis_pdf/OWNM/1302214L.pdf
. See page 15 of the manual for the information on setting the temperature set-points.
I hope this helps.
on Aug 13, 2019
Not finding what you are looking for?