Tip & How-To about LG WM-2277HW Front Load Washer
If you have the "OE" error code, which is really a "DE" (drain error) code, and you have checked the filter and it is clear, then most likely the impeller has come off the pump motor shaft. You can disassemble and push it back on, but it will come off again. I don't know if some type of adhesive would work, but I just replace the pump motor.
Drain water from small drain hose (or by removing filter) Remove the screw in the plastic recess by the filter, then use a putty knife on the left or right side to pop out the recess. Remove two more screws holding pump body to front frame of washer. Pull washer about 18 inches away from wall and tilt it back to lean against wall. You can reach through the large hole in the bottom of the washer base to access the pump. There is a plastic locking tab holding the pump body to the plastic washer base, but don't worry if you break that, as the screws (removed earlier) will hold the pump back on just fine. Pump motor is held onto pump body with three more screws. Replace pump motor with a new one and reassemble. On a difficulty scale of 1 -10, this one might rate a 5.5 or a 6.
Posted by Carl... on
Oct 29, 2017 | Washing Machines
Jul 08, 2014 | LG Dishwashers
May 01, 2009 | LG WM2688HWM TROMM SteamWasher
Oct 01, 2008 | Washing Machines
Sep 21, 2008 | LG TROMM WM2688H 4.0 cu.ft. Front Loading...
3,705 people viewed this tip
Usually answered in minutes!