Tip & How-To about Washing Machines
Removing the cabinet
UNPLUG the washer. There are two screws holding the control panel to the cabinet. Most models the screws are in front but, some models have the screws in back. They are on each end. Now raise the control panel up and let it rest on the hinges. Unplug the lid switch harness and locate the clips on each side (bronze in color) and release them. Now the cabinet will lift off the frame and you can set it aside.
How to replace a coupler Now that the cabinet is out of the way, remove the pump from the motor and set the pump off to the side. Remove the two screws holding the clips on the motor and remove the clips. Unplug the motor harness and on some models you will need to unplug the capacitor.
Now you will need to replace all three parts to the coupler. I use a ½” socket and a small hammer to force the coupler onto the motor and transmission shafts. Put the rubber part onto the coupler half on the transmission and then line up the post on the motor shaft with the holes on the rubber part and it should go on ok. Put the clips that hold the motor in place and plug in the harnesses.
Put the pump back on and the clips to hold it in place. Set the cabinet back on the frame. Make sure the lip on the front cabinet is under the front rail of the frame. Ease the cabinet on the frame making sure the two rear sides of the cabinet set down on the tabs of the frame.
Put the two clips back on that hold the cabinet and plug the lid switch back in. Fasten the control panel down and you are all set.
Posted by Victor on
Jul 18, 2009 | Whirlpool Ultimate Care II LSQ9564J Top...
Jul 01, 2009 | Kenmore 24032\24036 Top Load Washer
Jul 01, 2009 | Roper RTW4300SQ Top Load Washer
Jun 28, 2009 | Kenmore 24032\24036 Top Load Washer
Jun 19, 2009 | KitchenAid KAWS850L Top Load Washer
223 people viewed this tip
Usually answered in minutes!