Question about Washing Machines
Posted by Anonymous on
Means you have it taken back for a new one! Hopefully you used plastic to buy
Posted on Sep 27, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: indesit w123 washing machine
hi had a similiar problem on a year old washing machine after 3 engineers later who 1..put in a new circuit board...did not work 2...put in a heating element ...did not work 3...techican engineer..put in a new motor and repalced air pressure switch...bingo did work if your drum is turning slowly and does not wash how very well you may find ur motor is getting worn out..a problem..?? b careful they r £90 so make sure its that b 4 u change it my machine started to fill then almost immedately emptied out..then tured off then i had the flashing lights hope this is some help to u
Posted on May 29, 2007
SOURCE: Error display
E10 is a water supply problem first I would check your water lines.. and check the water valves to see if both are open all the way.. next check to see if the screens at the inlets are clear... and last you may need a new water valve in your wather.. let me know if you want to replace it yourself thanks...
Posted on Aug 31, 2007
To exit the TEST mode, press and hold down the "Start/Cancel" button until ALL of the console lights light up. Press both "Start/Cancel" and On/Off buttons simultaneously until " dOFF " appears in the display. The default setting will now appear and the machine can be used normally.
Posted on Feb 07, 2008
SOURCE: vibration problems
it could be a number of problems which are very common on the entire wma range.
1, drum bearings are really poor in these.
2, concrete block tapping, sometimes the bracket n the drums snap.
3, motor bracket snapped causing tapping.
i've found the plastic drums seem to be quite weak on the wma range to be honest so will more than likely be one of the above.
hope this helps
Posted on Jul 31, 2008
SOURCE: error messages EFO and E10
It is simple. The wrong soap or too much soap will caused EFO to flash. I overfilled the machine with soap by accident. It started flashing with EFO and I went nuts. What could be wrong with it now?! Too much soap or not the right kind of soap will cause this problem.
Plus, I found a sheet of paper that gives the codes.
This is better than when the strainer plug gets filled up and you have to take the machine apart to clean the little strainer.
Posted on Oct 25, 2008
Tips for a great answer:
Nov 22, 2016 | Hotpoint Washing Machines
Jun 05, 2014 | Hotpoint Aquarius WD640 Front Load...
Mar 15, 2010 | Hotpoint Aquarius WD640 Front Load...
Mar 02, 2010 | Hotpoint Washing Machines
Oct 06, 2009 | Hotpoint Aquarius WD640 Front Load...
Oct 04, 2009 | Hotpoint Aquarius WD63 Front Load...
May 11, 2008 | Hotpoint Aquarius WF000 Front Load Washer
May 03, 2008 | Hotpoint Aquarius WF000 Front Load Washer
Mar 28, 2008 | Hotpoint Aquarius WF000 Front Load Washer
161 people viewed this question
Usually answered in minutes!