Question about Konica Minolta bizhub 250 All-In-One Laser Printer
When the copier is on the network does the little leds flash at the network connection? ping the ip address of the copier what do you get.
Go into admin mode on the copier network setting what is your ip address, subnet and gateway reading did you replace a router? now the network is one system and the copier was never told this new info?
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
Posted on Feb 25, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I guess you mean the c350 is not printing while Windows said the job has been sent?
If so, it may have changed IP Address from the time you first install the Printer on Windows. Check the Ports setting of the c350 printer! e.g.
Network Pritners should have Static IP address or at least a reserved DHCP IP Address. Logon to your Router, check the MAC Address of the c350 and reserve/assign it a IP Address near the end of the DHCP range. Save the Router configuration and power cycle the c350. Confirm IP Address changed to the reserved IP.
Then you have to change all the PC's Printer Configuration of the c350's Port to update the reserved/assigned IP. Or remove the c350 from Printers and Faxes, then run the printer setup software again.
Posted on May 23, 2009
Please check the sensors and actuators ,open & close front door to reset nisfeed.Clarification Top feed = Automatic Document Feeder?If YES,please verify misfeed paper beetween coverplaten and feedbelt(Yellow).Is necessary disassembly the ADF.Good luck.You will find a little paper.
Posted on Jul 31, 2009
You have to be sure that you are connecting the printer in exact the same USB port. If you are connecting to a different port and not to the one from was disconnected, the Windows is installing another copy of your printer. Check this, I believe this is the solution to your problem.
Posted on Aug 23, 2009
Tips for a great answer:
Apr 01, 2014 | Konica Minolta bizhub 250 All-In-One Laser...
Feb 17, 2014 | Konica Minolta bizhub 250 All-In-One Laser...
Mar 22, 2013 | Konica Minolta bizhub 350 All-In-One Laser...
Jan 27, 2018 | Konica Minolta bizhub C250 All-In-One...
Jun 01, 2012 | Konica Minolta bizhub 350 All-In-One Laser...
Jan 11, 2011 | Konica Minolta bizhub C250 All-In-One...
Jan 07, 2011 | Konica Minolta bizhub 250 All-In-One Laser...
Jul 21, 2009 | Konica Minolta bizhub 250 All-In-One Laser...
Apr 24, 2009 | Konica Minolta bizhub 250 All-In-One Laser...
Apr 12, 2008 | Konica Minolta bizhub 250 All-In-One Laser...
124 people viewed this question
Usually answered in minutes!
Level 3 Expert
Level 3 Expert
Level 2 Expert