Question about Frigidaire Ovens

1 Answer

Oven and and command center are totally out. Range works but that

It worked fine last night, now it won't. Help!

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 112 Answers

You can check for an internal fuse that could be the cause, but in most cases, this is due to a faulty control board.

Posted on Nov 10, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Frigidaire oven won't work. top range works fine, but digital clock and digital display stopped working which works oven, so oven also will not work f11 code


Hello steve o - Typically error code F11 indicates a shorted keypad. Try resetting the range by unplugging it or flipping the household circuit breaker off. This usually will clear most false error codes. Wait approximately ten minutes and if the error code does not clear contact a professional to move forward accurately. Most likely the EOC on the range will need replacing.

Nov 12, 2012 | Frigidaire 30" Self-Cleaning Freestanding...

1 Answer

Hi Last night my oven just stopped working while I was baking. All the lights and clock went off and oven/broil controls are inoperable. The burners (and the electric ignition) continue to work fine. I...


You have a bad EOC electronic oven control unit, They are readily available from any parts house. They do not have instruction but are not difficult as it is just a few screws and swap out wire for wire. It may be a good idea to buy it from a vendor that allows returns of electrical items. Many do not allow returned electrical items. Please rate my answer and any comments are welcomed at least good ones:) Good Luck, Mastatech.

Aug 25, 2011 | Frigidaire 30" Self-Cleaning Freestanding...

1 Answer

I tried to cook a frozen pizza in my Tappan electric range last night (which required it to be preheated to 400 degrees) and it would not preheat at all, even after about a 3 hour wait. I just turned up...


http://www.appliancepartspros.com/partsearch/model.aspx?model_id=5153992&diagram_id=1251523#d1251523
your looking for part number 67 on that part breakdown
it is the bake element and if you inspect it im sure you will find it cooked or broken
befor you actually order the part take the unit out
unplug it
and inspect your wire connections to both sides of the element

Oct 17, 2009 | Tappan 30IN ELEC IGNa Oven

1 Answer

My oven display is beeping and blinking 'PBR' on the display. What does that mean?


I had this same problem last night.. I have been having problems with the oven shutting off on preheat.. That sort of stopped. Last night lost power to the house. When it returned the oven was beeping and flashing PBR. I turned off the breaker for a few mins. last night and it returned. It was bugging me so much that turned it off the whole night. Woke up this morning turned the breaker back on and it stopped. I don't think this is the total solution. I am thinking that eventually I am going to have to replace power board in this oven. Hope it works!

Sep 23, 2009 | Jenn-Air Ovens

1 Answer

Our frigidaire flat-top electric stove stopped working


Sound like you make have a loose neutral on the cord where it attaches to the range or in the electrical receptacle where it plugs in, you can check the cord by pulling the range out, remove the small access cover to the cord connection area, after you have unplugged it and just tightened all the nuts to all connections on the cord. I advise an electrician to check the receptacle. I hope this has helped you. Have a great new year.

Dec 28, 2017 | Frigidaire FEB27S5A Electric Single Oven

1 Answer

Oven not working


you would have to check the element for continuity. Also the oven sensor could be suspect and should ohm out at 1180 at room temp. if both those are ok then main control is probable. without schematic it would be hard to say for sure..there may even be a safety fuse blown.

Jun 13, 2009 | Kenmore 40494 / 40495 / 40499 Electric...

1 Answer

Elements in convection oven won't heat


DO you have a model number for that. I'm almost sure it's a thermal fuse in the back of the oven. Usually they go out during or after cleaning but that would shut down both elements. If you have the model (usually by the inside door look all over and up in the cavity) Then if you go to this link

http://www.searspartsdirect.com/partsdirect/index.action?intcmp=xsite_Sears

It will show you a breakdown of the oven and where it is. If you give me the model I'll show you what I'm talking about. Good luck.

P.S. if it the fuse it's a cheap fix, little hard to get in back of the oven but cheap!

Mar 04, 2009 | GE Ovens

4 Answers

Frigidaire oven won't work. top range works fine, but digital clock and digital display stopped working which works oven, so oven also will not work


my frigidaire oven will not light. The broiler works and the oven ingiter lights up, but the oven will not ingite. The electronic display does work.

Aug 25, 2008 | Frigidaire 30" Self-Cleaning Freestanding...

2 Answers

Thermador Oven won't heat after running self-cleaning cycle


SOunds like you need to reset the oven high limit switch. It should be located behind the grille obave the oven opening and below the control panel. There should be about 4-6 screws you need to take out to remove the grille to gain access. Turn the power of to the oven at the circuit breaker, then rech in with a screwdriver and push down on the little red button in the center of the hig limit until it clicks. the high limit should be about as big around as a quarter and have a wire going into one side and out the other. If this keeps tripping, you may have a bad cooling fan. When you run a self clean it should also run a fan to cool the components. You should be able to feel a breeze coming out of the bottom of the oven when the cooling fan (not the convection fan ) is running. If this fan doesnt run, it will trip that switch. Hope this helps!

Dec 08, 2006 | Thermador C301U Electric Single Oven

Not finding what you are looking for?
Ovens Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Ovens Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Bruce Denton

Level 2 Expert

273 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Frigidaire Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...