Question about Krups Small Appliances Espresso Machine
Error 05 I would normally associate with a distributor problem,
New barista seal
New tamping piston seals
New tank seal
It is not a job for the faint hearted.
Posted on Aug 29, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
After I changed piston sealing I get the same error 09. It was caused by missing connection to the thermoblock temperature sensor. In my case both connectors for thermocouple were cracked. They are located directly on the body of thermoblock, below two fuses, covered by rubber housing. After I solder them again on the position error 09 disappeared. Unfortunately it is necessary to open at least front panel of the machine. Moreover I tink that there is also important to save polarity of those two cables.
Posted on Aug 07, 2009
You can just removed the water tank filter (the cylinder inside the water tank) and washed it up. (Actually the filter should probably be replaced). Fix it back in the water tank and tide it safety upon the exit ring.
Don't forget to unplug the machine BEFORE doing this.
Next, restart the machine and let it perform the automatic self testing.
Posted on May 10, 2010
I can remove the bean container by pulling off the grind selector knob and removing the only screw.
Then remove the scute for the cleaning tablets. Then remove the two screws that were covered by the scute. Remove the water tank. Under the tank remove the two screws.
Then the trick where everyone seems to look for: The facade of aluminum can be moved off. Set the machine on the floor and pull hard upwards at the facade. This comes off (pull hard!) and four screw are uncovered. Remove them and pull then back housing of the machine (remove first the containers/drawers). Now the inner parts are freely accessible. Take photos and remove the components from top till bottom to get to the bad parts that need replacement. It's a lot of work but if you're handy you can get to the valve on the bottom of the machine. I have the same problem but haven't looked up the replacement part (can be expensive). Good luck!
Posted on Aug 07, 2010
Tips for a great answer:
Oct 17, 2012 | Gaggia 1003380 Accademia Espresso Machine
Feb 11, 2011 | Krups XP7245
May 31, 2010 | Krups Small Appliances Espresso Machine
May 10, 2010 | Krups Small Appliances Espresso Machine
Jun 06, 2009 | Krups XP4030 Espresso Machine
Mar 09, 2009 | Krups XP7225 Espresso Machine
Jan 06, 2009 | Krups XP7230 Compact Super Automatic...
Jul 10, 2008 | Krups XP4030 Espresso Machine
May 19, 2008 | Krups XP2070 10 cup Coffee Maker/15 bar...
Jun 26, 2014 | Krups Small Appliances Espresso Machine
1,322 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: