Question about Chevrolet 1995 Chevrolet Blazer S10/jimmy S15 Radio

2 Answers

When i turn on my heater my batery volt dial goes down

When i turn off the blazer it wont turn over until it cools down i have replaced the cable the runs from the battery to the starter before that i had to change a freeze plug that was behind the motor mount and the water was leaking on it i am thinking that the starter is bad but the auto stores are saying that it is something else and it is my only vehicle please help

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Prodigy:

    An expert who has answered 500 questions.

  • Expert
  • 547 Answers

You might have a voltage regulator problem. If the vehicles voltage drops by more than a volt or two when everything electrical is turned on, that's the most likely problem.

It could also be a bad connection somewhere after the alternator. Or, you have a failin alternator.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_29ad5d1dd86564b0

Posted on May 17, 2016

Ad
  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 15 Answers

It sounds like your heater moter has a short try unpluging it

Posted on May 24, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to light the water heater pliant light


If it's not electronic. Turn the dial to pilot and push in the pilot button and hold it, then put a flame to the end of the tube under the water heater, continue to hold until the thermocoupler warms up and release. If it goes out do it again only hold the button down longer. The turn the dial back to on..

Jun 21, 2014 | Whirlpool Water Heaters

1 Answer

I have a G6A-3E heater. didn't work untill I cleaned the terminals on the t,stat It works but shuts off befor the water is hot!


Take a multimeter or 12 volt test light and probe terminals on Therm & ECO for 12 VDC power while running. When it shuts down and wateris not hot, test for voltage again at those terminals, If you have 12 volts to side of therm that goes to ECO beside it, then therm is ok, but then check opposite side of ECO as well. If power on one side of ECO, but not the other, the ECO is faulty. Simply walk across with probe testing for voltage when you find no power at one terminal but not the other, it's faulty, replace it.

Feb 16, 2013 | RTO Atwood Water Heater - 6 Gal LP

2 Answers

Water sound when i accelerate my 2003 blazer


intake or vacuum leak? I dont know uless your more specific

Nov 06, 2011 | 2003 Chevrolet Blazer

1 Answer

Got a 84 k-5 blazer the back window rools down but wont go back up and the motor works but the cable that goes into the motor wont turn


I had a similar problem, but I could use a cordless drill to turn the cable. If the cable won't turn, you might try a new cable, since it might be broken in the middle. I had a bad wire in the tailgate, had to splice a new one, couldn't get at the wiring behind the glass. Have you checked the switch on the dash? I am having a problem with that, too. 26 years old, it doesn't spring back so well.

Nov 12, 2010 | 1984 Chevrolet Blazer

1 Answer

Why wont my 99 chevy blazer temperature warm up?


You may have vapour lock in your heater lines. Start engine, put heat lever on high, disconnect one of the lines on your heater core, the one on the flow out side, & see if you have any air coming out. Once antifreese comes out stick line back on & retighten clamp. Make sure your cooling system is topped off. Also your water pump may not be functionihg to it's maximum. Take rad cap off cold & view flow rate. If inadequate you may have to replace the water pump. Good luck!

Dec 09, 2009 | 1999 Chevrolet Blazer

2 Answers

2000 blazer power seat


The guy that posted the first solution...that works...My power seat module went bad , so I used a 12 volt batery charger on the wires to move my power seats.

Mar 19, 2009 | 2000 Chevrolet Blazer

1 Answer

Pilot going out


sounds like a bad thermostat.I am not to familiar with this problem.
sorry i could not be more help

Nov 23, 2008 | Heating & Cooling

1 Answer

Pilot goes out after heating cycle


Check regulator on the unit.
Check pilot unit on the heater
use soapy water to check for leaks if see bubbles turn off main gas supply valve.
always turn off gas supply before any checks or repairs are made
when all else failes call your local gas provider to check heater and gas supply

Nov 22, 2008 | Rinnai Desa Vent-Free Infrared Gas Heater:...

Not finding what you are looking for?
Chevrolet 1995 Chevrolet Blazer S10/jimmy S15 Radio Logo

309 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Audio Players & Recorders Experts

D. E. Hev

Level 3 Expert

1187 Answers

Marvin
Marvin

Level 3 Expert

85160 Answers

Lawrence Oravetz

Level 3 Expert

10543 Answers

Are you a Chevrolet Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...