Question about Mitsubishi WD62628 62" Projection HDTV
New lamp housing will not slid in to match up with sockets
In my case, to be more specific, the male socket fitting on the new lamp is held in a fixed place in the lamp housing by a small philips screw. When this screw is loosened the male socket fitting position can be adjusted. In my case I had to move the socket outward about 1/4" to come anywhere near matching up with the female socket in the TV. The only way you can know this is if you take the back off the TV and remove the outer housing part to see what's going on.
Posted on Dec 15, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Nov 06, 2012 | Mitsubishi Televison & Video
Aug 30, 2011 | Cadillac STS Cars & Trucks
1.Remove the lamp cover by pushing two grooves lightly with the flathead
screwdriver. You can see the lamp cover on the top of the projector. ( left side of the lens)
2.Loosen the two screws securing the lamp housing until the screwdriver
goes into a freewheeling condition. The two screws are not
3.Remove the lamp housing by pulling out the handle
4.Insert a new lamp housing until the lamp housing is plugged into the
5.Secure it in place with the two screws.Be sure to tighten the screws.
6.Reattach the lamp cover
7.Snap the lamp cover into place.
Replacing a new lamp automatically clears the lamp usage hours ok
Jan 27, 2011 | NEC MT1060 Multimedia Projector
Dec 19, 2010 | 1994 Buick Century
Oct 12, 2010 | 2006 Hyundai Sonata
Jul 28, 2009 | 2004 Honda Odyssey
May 04, 2009 | 2006 Chrysler Sebring
Apr 19, 2009 | Kodak Carousel 4400 Slide Projector
Sep 11, 2017 | Mitsubishi WD62628 62" Projection HDTV
766 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: