Question about Raymarine C80 GPS Receiver

2 Answers

Radar screen shows "no scanner". Would like resistance data for cable pin-out from display to scanner head.

Posted by on

Ad

2 Answers

Some cable test stuff
Remove the cable from the display, leave the dome connected
I thought the cable end had pin numbers but let me know if it doesn't,
the video pins are 1 and 2 which are located
either side of the key slot
Video pins 1 & 2 resistance 46 Kohms colors 1 white signal, 2
black return
Azimuth 12 &13 resistance 10 Kohms colors 12 purple azimuth +
, 13 grey azimuth -
Trigger 4 & 7 resistance 10 Kohms colors 4 orange trigger
+ ,7 yellow trigger -
Data I/O 6 & 10 resistance 160 Kohms colors 6 green data + , 10
blue data -
Approx. +/- 5 ohms tolerance.
Below is a pin chart of the display connector
key
2 1
5 4 3
8 7 6
11 10 9
13 12
Other pins on display connector
Battery - pins 3 & 5 both black
Battery + pins 9 & 11 both red
Shield pin 8
Dome connections
Video pin 8 white
Video rtn pin 7 black
Trigger + pin 6 orange
Trigger - pin 5 yellow
Data + pin 4 green
Data- pin 3 blue
Azimuth+ pin 2 purple
Azimuth - pin 1 grey
Battery + red
red
Battery - Black
Black
There was a note that some cables only have one set of battery
connections pins 5 & 9
Battery connections on 3 & 11 not present on all cables. You should
have the doubled power wires with the 4KW unit.
If the test results did not have the correct ohms then they said to
check it at the dome
If the dome checked ok, then the cable was bad, and to continuity check
the cable to confirm
a bad cable

Posted on Aug 24, 2008

Ad
  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 16 Answers

Hello Clifford,

This is an old message. Are you still having trouble with this or has it been resolved?

Posted on Dec 28, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Furuno radar 1715


Cek wiring to scanner, change reedswice sensor /heading sensor. If the problem not solve, change the display with the new one.

Oct 01, 2013 | Furuno 1715 LCD Radar System GPS Receiver

1 Answer

NMEA Output from Furuno 6" LCD Radar, Model 1623


No it does not output any type of radar video data.

Apr 27, 2010 | Furuno 1623 Radar 16nm Range

1 Answer

JRC 1000 MKII bearing pulse error on receiver screen. Connections to scanner good and scanner turning. How can I determine if the problem is in the receiver? How can I fix it? louonboard


Normally the bearing pulse comes from the bearing pulse generator built inside the motor. Every time the motor turns it sends a pulse down the line showing the radar that it is indeed spinning. There is also a Heading pulse that comes from an electric eye elsewhere in the housing. The other thing could be that the wire carrying the bearing pulse is not getting back to the display. More so than often, it's the motor. I would have the display sent out to be checked on a simulator if there is a marine electronicshop nearby.

Oct 27, 2009 | JRC 1000 MKII Radar GPS Receiver

1 Answer

No radar target images


Sounds like your video cable inside your radar cable. Also brings your Gain back to zero, STC back to Zero and rain back to zero. Next increase your gain until you see a picture. If none of that is working, check your cable then finally call a dealer.

Oct 15, 2009 | Furuno 1715 Radar 24nm Range

1 Answer

Hi, I have a Radar Screen. Furuno 1942 MK2 . What Radar Dome can i plug this into. I have a Furuno 1720 Dome


A 1942 is a 6 kw radar a 1720 is either a 1.5 or 2.2 kw dome. The two will not work together. Besides the cabling is different. Also the radar cable on a 1942 is round where as the 1720 is square. The 1942 display should work fine on a 1943 navnet radar.

Sep 24, 2009 | Furuno 1942 Mk2 Radar

1 Answer

C120 displays NO DATA SOURCE in the radar section of the screen. ohns resistance test checked out. what else can it be?


1. you must have the latest software 4.29 the new scanner dont work with the old Software.
2. Be shure that you have really put in the connector of the cable inside the plotter its not so easy.
3.
try the plotter on an nother boat with an working system than you will know if its a problem with the antena or Plotter

Aug 06, 2009 | Raymarine C80 GPS Receiver

1 Answer

Furuno 1715 Radar - 'NO HEADING PULSE'


More than likely the belt has come off again. This is a common problem with this radar. You'll need a small allen wrench to tighten it up again.

Jul 02, 2009 | Furuno 1715 LCD Radar System GPS Receiver

1 Answer

Radar Displays the image upside down


If this is on the radar screen, you'll have to set your heading alignment on your radar. The radar may be 180 degrees out. if this occurs on the plotter, then if you have a heading sensor attached or an autopilot, your heading may be off.

Feb 03, 2009 | Furuno NavNet vx2 GP1720C GPS Receiver

1 Answer

1621 radar will not show target


Could be the video wires in the radar cable

Jan 04, 2009 | Boating

1 Answer

Furuno 1622 doesn't work, water coming out cable at screen!


yes the cable should be replaced if you are lucky, the unit is still OK (display) Try the new cable, draped across the boat before rigging. If fault exists with new cable, replace system, or find a new display on ebay

Nov 17, 2008 | Furuno 1715 LCD Radar System GPS Receiver

Not finding what you are looking for?
Raymarine C80 GPS Receiver Logo

Related Topics:

631 people viewed this question

Ask a Question

Usually answered in minutes!

Top Raymarine GPS Experts

The Knight
The Knight

Level 3 Expert

76140 Answers

gerd butler

Level 1 Expert

20 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Raymarine GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...