Question about Ademco Computers & Internet
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Car alarm not working
Usually, the siren is mounted in the engine compartment along the firewall pointing downward to drain any water accumulation.
It will have red & black wires connected to it, and (if done professionally) black wire loom over the wires to protect them from heat and debris under the hood.
Posted on Jan 14, 2009
It seems that the hi-lo siren from the mobo indicates that the cpu is over hated.
1st of all, you need to go into the BIOS/CMOS setup to check if the temperature was boosting higher that the prefix alarm. If it's low, but gone up very fast after a few minutes, you need to update to the latest BIOS firmware, as it's part of the Fatal1ty problem.
you can download the bios here, be sure to read all the instruction before you proceed to update the BIOS firmware.
PLEASE BE EXTRA CAREFUL WHEN UPGRADING THE BIOS AS IT MIGHT KILLED YOUR MOBO.
you can always come back here and post a comment if you r no sure.
2nd of all, you need to check is the heatsink was fixed properly.
It's not your fault that's the fan wasn't fixed properly because the stock LGA-775 socket T heatsink's design wasn't a perfect one, and it has 4 very fragile fix-in clips. You need to check if all four clips were fixed firmly in the braket for maximum heat dicipation. It might be broken and you need to replace with another one.
You might need to replace the thermal paste to a better 1.
Please check your manual on how to diassemble the heatsink.
Don't forget to rate my solution, thanks!!
Posted on Jan 17, 2009
put a 12 vt test light on your 12vt output to see if the alarm is outputing,some alarms have to be programmed for positive output as some are negative output ie;set up to hook up to horns.Also double check your earth.
Posted on Apr 21, 2009
Also, on the ic7 g, the tiny fan on the northbridge chip can fail and cause the same symptoms. (Happened to me and I spent a bit of time re-applying thermal grease btwn CPU and heatsink only to find the siren still went off under stress. The tiny fan was an easy fix. )
Posted on Jul 28, 2009
Tips for a great answer:
May 13, 2014 | Basic Remote Vehicle Alarm System
Dec 28, 2013 | Dei Directed Viper Python 514n Soft Chirp...
Mar 19, 2017 | 5701 VIPER 5701 2-WAY ALARM w/REMOTE START
Mar 04, 2013 | 350 HV ESP Security System 350HV ESP
Mar 04, 2010 | Excalibur. K9-MUNDIAL-SS Entry Level Auto...
Aug 06, 2009 | Ademco CIA Modem
Apr 22, 2009 | Vehicle Parts & Accessories
26 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: