Question about Motorola Mag One BPR40 Two Way Radio

Open Question

Reset BPR40 - Motorola Mag One BPR40 Two Way Radio

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Motorola BPR 40 will transmit,but not receive through the microphone. Works fine as a handheld


You may have one of three problems: Your audio accessory jack is bad, you are using the wrong mic for the radio, or your mic is bad. Try the mic on a known good BPR40 and if it test good, if so, your BPR40 with the problem needs a new audio accessory jack. (Repair is available for this model.) We have found the BPR40 will only work properly with the remote speaker mic designed for it, despite some other Motorola mics appearing to fit the jack. Construction grade mic PMMN4013 is a good option, as is the lightweight PMMN4077.

Jul 08, 2015 | Motorola Radio Communications

1 Answer

Mag One BPR40 not powering


Contact Motorola Solutions (http://www.motorolasolutions/support)

Jun 26, 2014 | Motorola Mag One BPR40 Two Way Radio

1 Answer

How do you synch a set of Motorola MagOne BPR40 radios to a new set of the same radios?


BPR40 radios are dealer programmable using Motorola proprietary software and cable.

Jun 23, 2014 | Motorola Mag One BPR40 Two Way Radio

1 Answer

How do i remove the circuit board in the BPR40


PeteD.

Contact Motorola Solutions.


Get Support

Mark
Motorola Mobility Support

Mar 13, 2014 | Motorola Headset Mic Vl130 Pr400 Bpr40...

1 Answer

Fuse Location on Mag One BPR40


these usually use a diode for reverse polarity protection and no fuses. You will need a full schematic and probably a service manual.

Oct 14, 2013 | Motorola Mag One BPR40 Two Way Radio

1 Answer

Green light stays on bpr40


If this is after programming your radio needs repaired. We see this when some BPR40s are reprogrammed. Take the radio to your local service center or send to a qualified repair center.

Sep 12, 2013 | Motorola Mag One BPR40 Two Way Radio

1 Answer

Have two bpr40 need to find out the frequencys


The BPR40 is a dealer programmable radio. The frequencies would need to be read out using Motorola proprietary software. The only thing you can tell from looking at the radio is whether it is VHF or UHF. Model number AAH84K... is VHF and AAH84R... is UHF.
Best regards.

Aug 20, 2013 | Motorola Mag One BPR40 Two Way Radio

1 Answer

My magone BPR40 radio isn't sending when PTT is pushed. It is receiving fine. Any suggestions?


A couple of thoughts:
1) Check the mic hole and see if it is covered or clogged with debris.
2) Does your PTT button seem hard or the opposite, mushy? You could have an internal PTT issue. The PTT is a common failure part on 2-way radios. Feel around for the 'sweet' spot and see if you can make a simple or partial transmission, or if it will even momentarily open up the receiver on the other unit. If so, your radio is in need of repair. It would likely need a new internal PTT. (At most repair centers where the BPR40 is repaired the flat rate repair currently are around $69 for the BPR40)
3) Has any reprogramming been recently done on the radio? If so, double check the programming to be sure your PL/DPL code is set the same as your other radio.\
4) Check your battery. Trade batteries with the other unit and see if the problem changes. It takes more energy to transmit than to receive.

Best regards.

Jun 15, 2011 | Motorola Mag One BPR40 Two Way Radio

Not finding what you are looking for?
Motorola Mag One BPR40 Two Way Radio Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorola Radio Communications Experts

eradiostore
eradiostore

Level 3 Expert

1655 Answers

Anthony Ward
Anthony Ward

Level 2 Expert

396 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Motorola Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...