Question about Champion International Champion Power Equipment 46515 3500 Watt 196cc OHV 4cycle Gas Powered Rv

Open Question

Generator leaking from fuel shut off valve - Champion International Champion Power Equipment 46515 3500 Watt 196cc OHV 4cycle Gas Powered Rv

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel shut off valve


Powermate generators usually have a shutoff mounted to the bottom of the fuel tank. There is a knob at the bottom of the connector where the hose is attached to the fuel tank. Screwing it in (clockwise) shuts off the fuel.

Aug 30, 2012 | Coleman Powermate Portable Generator...

1 Answer

Fuel shut valve detached from bottom off fuel tank where it appears to have been glued on. How to reattach?


most have a rubber grommet that goes in the hole in the bottom of the tank and the shut off valve goes in the center

Aug 27, 2012 | Pramac Generator 5000 Watt Subaru EX27...

1 Answer

Generator is leaking fuel


On most Coleman generators, there is a rubber seal that literally evaporates if left in time. Most people don't even see it because it has gone. You must check if any seals are missing. Make sure that the gas regulator is screwed as tight as it can go because if it isn't, it will leak like a sib. Last problem could be the open and shut valve is stuck which is another thing that happens when it sits over time without using it. You need to start it up and hold the choke and that will stop the leak and let it run for a couple of minutes and let go of the choke. It should open and close the valve with no problems after that.

Aug 27, 2011 | Coleman Powermate Premium Plus 6250W...

2 Answers

Generator is leaking gasoline out through the carburator when not running. Also, fuel shutoff valve at bottom of gas tank will not shut off completely. What are probable causes and price to fix ??


Most often fuel leaking out the carb is caused by a needle and seat problem in the carburetor / the float level shaft screw may have come loose due to the vibration of the engine ,this will cause a leak issue with the needle and seat as well. To complete the repair the carb will have to be removed and cleaned. Replace the needle and seat if necessary an then replace the carb.

May 30, 2011 | Coleman Powermate Powermate 5000W...

1 Answer

Colman Powermate Generator will not stay running


This overflow can be caused by:

1. The float sticking

2. Gas inside of the float air chambers

3. The needle and seat have debris in them or a r damaged.

It is not a difficult fix but it does mandate removal of the carburetor float bowl.

You could probably do this yourself. It is much easier if you place the generator on a high work area so you can see the float and needle once you have the float bowl removed. Just make sure you do not drop the float assy so far that the needle comes out of the seat unless you have to remove the hinge pin SCREW for the float to clear the debris near the needles' pointed rubber head.

Thanks for using FixYa

Kelly

Mar 22, 2010 | Coleman 1850 Watts Generator Each...

1 Answer

Onan Generator stopped working in motorhome because the gas got too low. I blew out the front fuel filter,changed oil and filter, air filter, one spark plug and now it won't start. Is there a fuel shut...


Yes it wil not let you run your motorhome out of fuel they set it up that way so you dont strand yourself you may have a air bubble in the fuel line to the generator try blowing air generator fule line back into the tank

Jan 31, 2010 | Watts Onan Portable Generator - 4000 ,...

1 Answer

Fuel leak


Have you tried to tighten the generator onto the valve assembly using pliers? This worked for me.

Jan 24, 2010 | Coleman 2 Burner Dual Fuel 424-700G Grill

1 Answer

My Coleman Generator Model 19G412 has a fuel shut-off screw/valve. It was in the off position. I needed to use the generator, but when I tried to turn the screw/valve to the on position, it would not turn....


explore the possibility of removing & replacing the 'petcock'[fuel valve] in the tank.drain tank,remove gas line,unscrew petcock retaining nut at tank & replace.

Oct 12, 2009 | Coleman Powermate Powermate 5000W...

1 Answer

Fuel leaks from around the valve at the 5 gal plastic fuel tank


you twist the whole valve after disconnecting the hose...
get a new one and put it instead...
if u have any further questions let me know:
sal_kh_sab@yahoo.com

Jun 29, 2009 | Coleman Powermate Powermate 5000W...

Not finding what you are looking for?
Champion International Champion Power Equipment 46515 3500 Watt 196cc OHV 4cycle Gas Powered Rv Logo

Related Topics:

800 people viewed this question

Ask a Question

Usually answered in minutes!

Top Champion International Electrical Supplies Experts

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Gene Haynes

Level 3 Expert

5353 Answers

Brad Brown

Level 3 Expert

18087 Answers

Are you a Champion International Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...