Question about GE Nautilus 24" Built-in Dishwasher

1 Answer

Drainage Cycle won't drain

My GE Nautilus Dishwasher won't go through the drain cycle. All tubes are clear and the disposal hole is clear. I took apart the filter in the bottom of the dishwasher and there is another filter with 2 metal pieces which turns and I think this could be part of the drain cycle. Could I possibly need a new motor for this peice. Thanks for any help.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 111 Answers

Pump is probably bad.

Posted on May 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dishwasher won't drain all the way


A dishwasher will never drain all the way. It is designed to hold water as to not let the pump run dry and keeps the seals preserved.

Jun 03, 2017 | GE Nautilus 24" Built-in Dishwasher

1 Answer

Water didn't drain, left in bottom of washer tub


I had similar problem and it ended up being a clog at the point where the drain hose meets the garbage disposal. I had to unhook the hose and clean out the food that had accumulated (horrible smell). You may have to stick a screwdriver into the garbage disposal hole where the hose fits and clean the food out there also. Then put the hose into a bucket and run a few cycles to ensure the hose is free.

Aug 01, 2009 | GE Nautilus 24" Built-in Dishwasher

1 Answer

Dishwasher drains but leaves behind about 1/2" of standing water


Water standing in the bottom of the tub is normal.
A small amount of clean water around the outlet on the tub bottom at the back of the tub keeps the water seal lubricated.

Jun 22, 2009 | GE Nautilus 24" Built-in Dishwasher

1 Answer

It all started when garbage disposal went out. dishwasher filled


no but keeping hte screens anddrains clear will, no real majic answer here ohter then taking apart and lookin for the blockage

Mar 19, 2009 | GE Nautilus 24" Built-in Dishwasher

1 Answer

GE NAUTILUS GSD3200-J00WN DISHWASHER WON'T COMPLETELY DRAIN


Hi,


Here is a tip that I wrote that will help you with your dishwasher not draining problem...

Dishwasher Problems - Water will not drain out

heatman101


1

Dec 27, 2008 | GE Profile PDW9880NSS Stainless Steel...

1 Answer

My ge nautilus dishwasher won't drain can you help?


gsd4200joobb dishwasher ge wont drain i can feel the hoses pumping water not going out thou and garbage disposal clear

Aug 25, 2008 | Dishwashers

3 Answers

GE Nautilus Drain Problem


I had the same problem (water remaining in the bottom) after the rinse cycle. FYI my GE Nautilus is 7-years old.
(1) I disconnected the drain tube at the garbage disposal unit (in the sink) and, using a wire coat hangar freed a 'plug' of sludge located at the spot where the drain tube clamps onto the garbage disposal. I blew into the drainage tube to further clear other 'plugs' I observed but could not reach w/the coat hangar.
(2) I unscrewed the Filter/Strainer on the inside (bottom) of the dishwasher; and further removed the inner filter; cleaned both out.
(3) Re-ran the dishwasher thru complete wash/rinse cycles (to check for leaks. There were none.
Finally, upon completion of the w/r cycles there will always be a small pool of water (residing in the filter area). However my dishes are clean and (after 7-years) checking the drain tube and filters was a breeze.
Hope this helps

Jul 04, 2008 | GE Nautilus 24" Built-in Dishwasher

1 Answer

Dishwasher not draining


remove the clamp holding drain tube to disposer, unplug disposer, and see where clos is its gotta be right there, UNPLUGGED.UNPLUGGED you can stick a screwdriver thought drain hole in side of disposer to clear debris

Feb 22, 2008 | GE 24 in. Profile PDW9880JSS Built-in...

1 Answer

GE Nautilus won't drain after Rinse Cycle


Check disposer plug. If a garbage disposer has been recently installed, it is possible the disposer drain plug was not removed. The drain plug is a plastic piece in the disposer that blocks the hole where the dishwasher hose connects. Also check the hose connected to the disposal. Mine apparently had a kink in it. When I straightened the hose the dishwasher drained at full speed (I recently had a plumber re-route a hot waterline. He must has bent the hose). Hope this helps. If not go to the GE website. That's where I found my answer.

Nov 03, 2007 | GE 25 in. Nautilus GSC3400J Free-standing...

2 Answers

GE Nautilus Dishwasher Problem


check water level is ok. check its heating. open door when in operation and check if spray arms are rotating. if not, take them out, run water into centre hole and check water comes out of jets. note the spray arms only rotate with water coming out of angled jets at end

Apr 19, 2007 | GE 25 in. Nautilus GSC3400J Free-standing...

Not finding what you are looking for?
GE Nautilus 24" Built-in Dishwasher Logo

Related Topics:

438 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Dishwashers Experts

Mike

Level 3 Expert

4363 Answers

Archie Ferrarini
Archie Ferrarini

Level 3 Expert

869 Answers

Vitally Alcher

Level 3 Expert

1645 Answers

Are you a GE Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...