Question about Cobra 148 GTL 120-Channels Base CB Radio
Posted by Anonymous on
Five pin /4 pin? (white D-104?)
five pin= 1-audio,2-shield,3-RX,4-comm,5-TX
Posted on Feb 14, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: mic wiring
Hello, In case you haven't found it yet, here is for a 2510/ which is a cousin of a radio.
1 - Modulation/ Audio/ White
2 - Ground/ Shield
3 - Transmit/ Red
4 - up button/ NC
5 - down button/ NC
Thats if the D104 is a 4 wire, Mechanic
Posted on Nov 05, 2008
SOURCE: 148 gtl 5pin
Looking from inside the radio at the mic jack, with the nub down. Starting from the left is pin 1, pin 2, pin 3, pin 4, and pin 5.
here is the colors that should be attached to each.
1 is white.
2 is sheild.
3 is black.
4 is red.
5 is blue.
Hope this helps. Take care in soldering. It is easier to reach the pins if you remove the 4 screws that hold the face plate on. Be careful not to pull another wire from somewhere.
Posted on May 03, 2009
SOURCE: I have a astatic d104
If you bought the mic new it came with a sheet telling what wires do what, most of those are six wire mics.
In your radio: 1=shield, 2=audio,3=transmit, 4=receive.
On most astatic mics shield is braided shield wire, audio is white, transmit is red and blue is receive.
The other two wires should be yellow and black, the yellow will not be needed and you may have to connect the black to either pin one or pin 4.
Best way to do this is wire the shield and receive first and connect mic, if you have receive, then go for the audio and transmit.
There are a couple of versions of this radio so you may have to experiment to get it right, Keep the solder connections neat and the wire short.
Let me know with a comment here if you have questions.
Posted on Dec 11, 2010
The wiring is not likely to be the same.
The information on the radio is here:
You will likely need to open up the mic to identify what your wires connect to to determine the correct oreintation. it is possible too you may find one of the models listed was used by Barjan and is nothing more than a rebranded microphone.
Posted on Feb 19, 2012
Tips for a great answer:
Dec 15, 2017 | Radio Communications
Nov 09, 2013 | Midland 1001Z 40-Channels Base CB Radio
May 05, 2011 | Uniden GRANTLT 40-Channels Base CB Radio
Sep 25, 2010 | Galaxy Radios DX-949 40-Channels Base CB...
Feb 05, 2010 | Astatic 636L Noise Canceling Microphone...
Jul 12, 2009 | Magnum DeltaForce CB Radio
Aug 30, 2008 | Cobra 18 WX ST 40-Channels Base CB Radio
190 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: