Question about Champion International Champion Power Equipment 46515 3500 Watt 196cc OHV 4cycle Gas Powered Rv

Open Question

Champion c42412-1 runs but no output

My champion generator will start & run ok but there is no output. I ran it for a year, it sat for 6 mo. then I started it, tried to run some tools off of it & there's no output.

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
KMusselmann
  • 247 Answers

SOURCE: Champion Vantage 35 - mower will not keep running

More than likely the jet in the carb is somewhat clogged. Did this just happen after sitting for the winter? If so, start the mower and when it starts to die pump the primer to keep it running. Sometimes it will clean itself in a few minutes. If not, carb cleaner or take the carb bowl off and clean the jet.
Hope this helps
Kurt
Pls rate the answer

Posted on Mar 20, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

7500 champion generator used breakers were tripped they wouldnt reset but ran great good voltage for about 3 weeks now it still runs great but the voltage meter bounces on 0 wont power nothing


If it has sat, it may have lost it's rotor residual magnetism.
Disconnect the rotor field wires at the AVR or on the exciter/brushes. Note they are polaroty sensitive. Connect a 12V battery to F+ and F- (note polarity) and momentarilly power from the battery for a few seconds. DO NOT forget to disconnect the rotor/exciter field wires first or the voltage regulator will be damaged.

If it hasn't sat check voltage regulator, rotor resistance, and stator resistance, and for shorts to ground.

Dec 26, 2014 | Electrical Supplies

1 Answer

Only runs with choke


There is an air leak in the seals somewhere between the carb and the intake manifold. You are getting too much air! ALL of those seals need to be changed, As the paper seals age they develop small cracks that kill the vacuum made by the engine to pull in the gas/air mixture!

Dec 23, 2012 | Champion International Champion Power...

1 Answer

Cant get my power ate 8750 to start. Ran fine last year. Have changed spark plug, aded fuel stabilizer, will starting ether help?


My son in law drained the carborator 3 times to get the old gas out. Also put in an additive to the gas. He figured our unit had sat too long and the gas was getting old. It is running fine now. Just need to figure out how to idle it down.

Oct 28, 2012 | Coleman Powermate 7,000 Watt 13 Hp...

1 Answer

Yamaha ef1000is was rained on, starts and runs after unplugging wire plug from generator, runs when replugged, but no electrical output


Sounds like the rectifier got fried. Moisture in these units is a dangerous thing. Even if you feel the unit sat long enough to dry ouit, it sometines will hold moisture in the electrical componants.

Jan 15, 2010 | Yamaha 1,000 Watt Portable Generator...

1 Answer

I have a Hobart Champion 10,000 welder generator. It runs but I am getting no juice out of it. Won't weld or put out power to run anything.


measure ouput on ALL available sockets - anything?
Take cover off electric motor-generator, visually inspect windings.
Measure continuity of all stator windings (2 or 3 points usually)
Measure continuity of stator thru brushset.
If all measures ok - has to be AVR module.

There is no mistery in generator - just stator to induce and rotor to obtain voltage.

Jan 01, 2010 | Hobart Champion 10,000 All-in-One...

Not finding what you are looking for?
Champion International Champion Power Equipment 46515 3500 Watt 196cc OHV 4cycle Gas Powered Rv Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Champion International Electrical Supplies Experts

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Gene Haynes

Level 3 Expert

5353 Answers

Brad Brown

Level 3 Expert

18072 Answers

Are you a Champion International Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...