Question about Sharp AR-M355N Copier
Have you tried the sim 25-1 to see what the toner value is? Sharp pretty much just says check the connectors and the toner sensor then replace the toner. If you are using refilled toners that could be the issue. These are the troubleshootings steps for F2-02 in SM. Techsupport Printer
Posted on Mar 06, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: F2-02 error on Sharp AR-M237
on this code you may have to clean out the developing unit and start with fresh developer. Make sure the developer unit is not leaking from one of the bearings. You may need a tech for this one...
Posted on May 26, 2008
The CRUM chip is what tells the copier that the correct toner is installed. It is specific to the toner cartridge. If it is a new cartridge then it should have a new CRUM chip and there should be no problem. If it is a recharge it's possible that the chip was not changed or the wrong one was used.
Posted on Oct 16, 2008
the DK message means it is time to replace the black drum unit. the drum unit is called an ARC26DU. open the front cover. remove the toner cartridge/s by lifting the green
lever and pulling the toner out. Open the left side door. look at where
you just pulled out the toner and there is one screw (facing you)
holding each drum in place - loosen the screw and pull the drum unit out
towards you....slide in the new drum unit.
to reset drum counter go into SIM mode by pressing the following keys one after the other "P" "*" "C" "*" then 24 and start/copy key then 7 then select the color drum you are replacing and confirm reset. make sure copier restarts afterwards
DO NOT refill these toner cartridges (even if you can find someone to do it) The toner cartridges for these machines have generally had ongoing problems as far as longevity and quality - refilling them will only make it worse.
Posted on Apr 23, 2009
Open up the large front door, it will swing downwards. At the top section you'll see four boxes with front handles. Each of the boxes is a slide-out container of toner.
Follow the instructions on the new toner box to prepare it for the copier.
You'll note each toner box has a color designation (on a plastic label just above where you grab). Simply grab the handle on the one you need to replace, pull it out and then slide in a new one.
Also note there are four colors: Yellow, Magenta, Cyan and Black. The LCD screen should indicate which toner bottle(s) to replace.
Posted on Aug 31, 2009
It is always recommended to use OEM toner. The toner you need if AR-310NT
Posted on Oct 12, 2009
Tips for a great answer:
Apr 12, 2015 | Sharp Office Equipment & Supplies
Jul 06, 2011 | Toshiba 1360 Black and White Copier
Aug 25, 2010 | Sharp AR-207 Copier
Aug 17, 2010 | Sharp AR-5316 Advanced Digital Imager...
Jun 23, 2009 | Toshiba e-Studio 202L Copier
May 18, 2008 | Epson AcuLaser C4000 Printer
774 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: