Question about Eureka Vacuum Cleaners; AIRSPEED One Multicyclonic Upright
My Eureka Multicyclonic vaccuum cleaner isn't picking up any dirt and the roller isn't spinning. What can I do to solve the problem?
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
That problem can be caused by the belt being stretched out and even though it is spinning when you look at it, with the resistance of the carpet it will stop.
With a model number I could tell you exactly how to change the belt, but most of the whirlwinds I've seen are similar.
You need to gain access the belt and roller. On most models there are two screws on the top of the nozzle inside one of the four indentions that run along each side. Once you take those out it allows you to take the hood off.
Remove the brush roller and old belt. Wrap the new belt around the motor shaft and place the roller through the belt loop and use the roller as leverage to stretch the roller back into the roller housing. It will take a little muscle. Give the roller a spin by hand before putting the hood back on. It should spin easily. If it doesn't then you might have pinched the belt and need to free it or the belt will just burn up when you turn the unit on.
A clog in the hose going down to the nozzle would also cause this problem, so check that hose when you take the hood off.
Posted on Nov 30, 2008
SOURCE: eureka vacuum cleaner
That means that the belt
is starting to wear. When the belt starts to stretch it can't turn the
roller brush against the resistance of the carpet and therefore doesn't pick up well. You simply need to change the belt. Here
is a link to the belt you need and to the manual:
Eureka 2961AVZ Belts
Eureka 2961AVZ Owner's Guide (3.4 KB download)
Posted on Nov 19, 2009
The belt is probably worn, stretched or broken that is why it is not picking up. Here is
a link to the owners manual which has instructions and a link to the
belt you need.
Eureka Altima Owner's Guide
Eureka Altima Replacement Belts
Posted on Nov 20, 2009
Posted on Jan 02, 2010
Tips for a great answer:
Aug 25, 2018 | Eureka Vacuums
Jul 28, 2017 | Eureka Vacuums
Jul 25, 2015 | Eureka Vacuums
Sep 18, 2014 | Eureka Vacuums
Sep 13, 2014 | Vacuums
Aug 04, 2014 | Eureka AS2030A Airspeed One Pet Bagless...
Jan 27, 2014 | Eureka Vacuums
1,452 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: