Question about Kodak EASYSHARE G610 Thermal Printer

Open Question

How do I load new ink into g610 Kodak printer came with paper and new ink cartridge but wont fit into the white cartridge that was in the g610 help

Have new ink cartridge how do I fit it

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: not recognizing new ink cartridge

We had the same problem and tried all steps Customer Service suggested each time; after several calls, it was determined we had a defective printhead... Kodak sent a new printhead, new ink cartridges w/ an envelope to return the ones I was using.
Apparently it's a common problem with this model; especially the earlier ones. Have had NO problems since the printhead was replaced.

I would suggest if you have recurring problems (even after Customer Service directives), call and ask if you might have a defective printhead.

Posted on Jan 16, 2008

Ad
  • 1 Answer

SOURCE: Help with my Kodak EasyShare G610 printer

Have you tried cleaning the paper feed rollers with a slightly damp, lint-free cloth? You'll have to remove the paper try first. If that doesn't work you may have to remove the ink cartridge and tighten the roller. I had to call the Kodak technical support to get help with this. Hope this helps.

Posted on Nov 19, 2008

  • 2715 Answers

SOURCE: EasyShare G610 Ink only wanted.

Start here:

http://www.kodak.com/global/en/service/products/ekn033119.jhtml?pq-path=10734
Can I purchase the ink cartridge and the paper separately for my printer dock?...No, you cannot purchase the ink cartridge and the paper separately....FAQ
http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=10734/7269&pq-locale=en_US

Posted on Jan 17, 2009

  • 1 Answer

SOURCE: Kodak G610 printer dock won's communicate with computer

You know I had this same problem for a while as well. The only solution I found was that I HAD to use the Kodak Easyshare software in order to print anything with it. (That was the case with my XP desktop and my Mac laptop...). But sometimes it still would not spool properly and would require unplugging the printer and plugging it back in to reset.

Posted on Jan 26, 2009

  • 1 Answer

SOURCE: kodak #G600 printer dock/roller won't pull paper through

I read this solution to a problem someone else was having which was similar to my problem. I wiped off the roller with a damp cloth, made sure it was dry and that's all it took to allow the roller to be able to start to pull the paper through. - thanks for the help!

Posted on May 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cant get new ink cartridge to go in


Probably a piece of the old one is obstring it.

Dec 25, 2017 | Kodak EASYSHARE G610 Thermal Printer

3 Answers

Can i print using black ink when im out of color ink it wont let me even though ive changed the settings to print colors as black and white


That's the way Kodak works
It won't allow yu to do anything if any of the lights are flashing or there is a error message

NO RESOLUTION

Get your color ink cartridge replaced by Kodak.
Just say its a new color ink cartridge and printer is saying its empty!!

Hurraay you'll get a free color ink cartridge

Jan 25, 2010 | Kodak ESP 3 Multifunction Printer/ Copier/...

1 Answer

Not printing in color and black/white copy not clear, light in some places


Dear sir
good day
to fix up such problem
Clean the printhead, then print and
  1. Verify that inkjet paper is loaded in the paper trays.
  2. On your desktop, start the KODAK All-in-One Home Center, then select the Help [?] icon.
  3. From the Help menu, select Maintenance, then select Printhead Cleaning. The On/Off light flashes green during the cleaning procedure.
  4. When the On/Off light glows a steady green, press Photo + Copy simultaneously to print a demo sheet
and you have to Replace ink cartridges.
IMPORTANT: Make sure you are using KODAK Ink Cartridges. Your KODAK All-in-One Printer is designed to work with KODAK Ink Cartridges. Kodak is not responsible for the compatibility or performance of either non-Kodak brand ink cartridges or refilled ink cartridges. To purchase KODAK Ink Cartridges, go to KODAK Ink Cartridges & Photo Value Packs.
  1. Lift the printer access door, then remove the ink cartridges from the printhead.
  2. Insert new KODAK ink cartridges into the printhead, then press down firmly until you hear the cartridges click into position.
  3. Close the printer access door, then make the same print.
and you can point to the website below for further information
http://www.kodak.com/global/en/service/repair/troubleshooting/troubleshooting.jhtml?pq-path=5224/6198

thanks

Dec 18, 2009 | Kodak EASYSHARE 5100 All-In-One Printer

1 Answer

I have a kodak g610 printer dock and the paper is not being taken into the printer correctly and the printer keeps sending a message to unplug for 10 seconds and try again, any ideas


-Try to Unplug power cable for 10secs
-Remove paper try from the printer
-Make sure you are using the extralife paper or the thermal paper that came from the cartridge
-before you put the paper tray on the printer clean first all the rollers of the printer using a clean cloth
-Now if your done put it back now the paper tray
-Plug the power cable back
-Then do a test print.

If these solutions did not solve the issue please call kodak toll free 1 800 235 6325 and have it repair. GudlucK

Nov 02, 2009 | Kodak EASYSHARE G610 Thermal Printer

2 Answers

My kodak g610 is not printing ink on paper and i have a brand new cartridge


It sounds funny but I have seen this so try it.Have you removed the protective strip on the contacts of the cartridge? the bare contacts must touch the printers.If I didn't see this happen I would not post it,it does.Many people in a rush to install make this mistake.Good Luck.

Sep 05, 2009 | Kodak EASYSHARE G610 Thermal Printer

2 Answers

Can't remove used ink cartridge from G600 Printer dock???


Hold the transfer button down then hold the left arrow. Make sure the printer is on. Should here some clicking noise. When it completes then remove the ink cartridge.

Jan 24, 2009 | Kodak EASYSHARE G610 Thermal Printer

1 Answer

Ink cartridge won't go in.


Normal 0 Double check to make sure you have the right cartridge for the printer. This is a common mistake people are making. It’s easy to do.
Hope this helps. Bud

Jan 06, 2009 | Kodak EASYSHARE G610 Thermal Printer

1 Answer

Help with my Kodak EasyShare G610 printer


Have you tried cleaning the paper feed rollers with a slightly damp, lint-free cloth? You'll have to remove the paper try first. If that doesn't work you may have to remove the ink cartridge and tighten the roller. I had to call the Kodak technical support to get help with this. Hope this helps.

Nov 01, 2008 | Kodak EASYSHARE G610 Thermal Printer

2 Answers

5300 kodak eazyshare printer


Well, here is the proper way of fixing or troubleshooting that paper jam error in your printer

Open the printer access door and remove both of the ink cartridge, then remove also the printhead, after that close the printer access door, without those parts. Then it will show a message in the printer screen, "Printhead is missing or has come loose" or "Printhead Not Detected" Install the printhead, just the printhead without the ink cartridges. After that close the printer access door. Then it will show you a message"Ink cartridges is not installed,install ink cartridges". then open again the printer access door, then install the black ink cartridge without the color ink cartridge. then close the printer access door, then message must be " Color ink cartridge is not installed, install color ink cartridge" then install the color ink cartridge." the message must be,"New printhead is detected calibration require, load paper and press start"

Thats the way of overiding the paper jam error message of your kodak all in one printer
hope this will help you guys

by: E.brown

Happy Printing(", )
Kodak AIO tech support 1-800-421-6699

Jun 04, 2008 | Kodak EASYSHARE 5500 All-In-One InkJet...

Not finding what you are looking for?
Kodak EASYSHARE G610 Thermal Printer Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kodak Office Equipment & Supplies Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Clive
Clive

Level 3 Expert

4345 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Kodak Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...