Question about Bose Wave Radio

1 Answer

Why does it display 'please wait' and won't turn on?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 917 Answers

Sounds as stuck in a MODE , Unplug , & re try

Posted on Feb 06, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oce Varioprint 6250 is telling me I have paper in the Preheat Unit and TTF. Everything is cleared but it won't reset.


To reset turn OFF tghe copier press and hold the Utility key and turn ON the copier and wait then the display scree trouble reset.Touch the screen and turn OFF the copier,wait 1 minute and turn ON.

Feb 20, 2013 | OCE Office Equipment & Supplies

1 Answer

When machine is turned on from the off position it does not go into rinse mode message comes up to hot please wait and yet the machine has been turned off for at least 20hrs


the power on sequence for the XP9000 is
1) Internal diagnostic
2) if no cold water, display notice and wait for water level in cold water tank
2) if water heating block is not hot, display notice and wait for block temperature
3) display "Rinse Press Hot Water" notice and wait for button press
4) rinse
5) display "Select Beverage" and wait for button press, ground coffee flap, or other input switch state change.etc...

in short... its doing what its supposed to.

Please consider reading the manual supplied wih your XP9000 or downloading the manual if you don't have it.

Nov 10, 2011 | Krups Super Automatic XP 9000 Espresso...

1 Answer

The display will come on but it will not operate - timer works - display works - it just won't start


Hi from retired Englishman in SW France,
Just in case it is waiting for water to fill it try this-

If you have checked that the hot and cold water taps are turned on fully and the hoses are not kinked or squashed at the back, it is worth while checking both the hot and cold water inlet filters. Turn the taps off and remove both hoses at the washer end. Inside each inlet port there is normally a little filter which should just slide out. Clean if necessary and replace each one and the hoses. If after turning the taps back on there is no improvement, the problem is symptomatic of a malfunctioning hot or cold water control valve. Sorry but it needs a service call and a check that it isn't the control PCB ;-0(

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck,
John C

Aug 20, 2011 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

My infoglo has stopped displaying information however the unit itself is still spinning. Please advise


try unpluging the unit, remove the batteries and replace them, disconnect the phone lines and wait before about five minutes and do a fresh hook up. Do everything you did when you first bought it. If it still won't display then you unit may have fallen and the leds connections could have been dislodged.

I hope your unit reboots. I have a Discovery Channel Blue Globe.

Apr 27, 2011 | Wave Industries OLY-OL3000 Globe Phone

2 Answers

The display just keeps blinking F05 and the key won`t go away so I can`t open the door..... please help me


  • Check the Water Temperature Sensor, Heating Element and Element Relay
  • Check connections to the Sensor, Heating Element and Relay
  • Dec 23, 2010 | Washing Machines

    1 Answer

    PRESS POWER AND UNIT JUST SAY WAIT


    Unplug unit from AC..Wait 5 minutes , plug into AC + try to turn on.
    If nothing , make sure ALL your speaker wires are plugged in and try again.

    Let me know...Thanks

    Feb 06, 2009 | Panasonic Audio Players & Recorders

    3 Answers

    Hp laptop dv2500


    Try taking the battery out and then restart with only your external ac power connected.

    Sep 18, 2008 | HP Pavilion dv2500t Notebook

    1 Answer

    Please wait is all the display says


    Replace Your Hard Drive. It will fix your problem.

    Nov 20, 2007 | Ricoh Aficio 2022 All-In-One Laser Printer

    Not finding what you are looking for?
    Bose Wave Radio Logo

    Related Topics:

    905 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Bose Audio Players & Recorders Experts

    The Knight
    The Knight

    Level 3 Expert

    76140 Answers

    Steve Allison
    Steve Allison

    Level 3 Expert

    5569 Answers

    Ekse

    Level 3 Expert

    13434 Answers

    Are you a Bose Audio Player and Recorder Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...