Question about Chevrolet 2004 Chevrolet Aveo

Open Question

How do I remove the brain box on a 2004 chevy aveo

We are replacing the clutch and have reached the point of removing the starter, but we can't find a way to get to the top bolt other than removing the brain box. How do we disconnect the brain box without damaging it?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
rockitman187
  • 2559 Answers

SOURCE: Removal of Rear Brake Drum on 2004 Chevy Aveo

1.Release parking brake.
2. Apply the brake pedal at least 10 times.
3. Raise and support vehicle with jack stands, etc.
4. Remove the tire and wheel assembly.
5. Remove the lock ring and the caulking nut from the spindle.
6. Remove the drum from the spindle.
Note: Pull the drum straight off the spindle.

There is an opening on the inside for adjusting the tension,It's under a rubber cap.You can use a screw driver to make the adjustment

Posted on May 13, 2009

Ad
  • 1 Answer

SOURCE: Chevy S10 Pickup Starter. Removed the two bolts

Just changed a starter in a 94 S10 4x4. The only way to remove the starter was to take the passenger side exhaust manifold off and bring the starter out that way. Installation the same in reverse. Hope this helps. Don

Posted on Jun 25, 2009

tntjasmine
  • 24 Answers

SOURCE: Rear speakers for Chevy Aveo

you can access them from under the package tray inside your trunk compartment

Posted on Aug 26, 2009

  • 20 Answers

SOURCE: 2004 chevy aveo cylinder head bolt torque how many

Step 1: 18 lb.-ft.
Step 2: additional 60 degrees.
Step 3: additional 60 degrees.
Step 4: additional 60 degrees.
Step 5: additional 10 degrees.

Each step involves starting at the center two bolts of the head and alternately tightening in a criss-cross pattern, ending with the bolts on the outer edge of the head.

Posted on Sep 14, 2009

c17hydro
  • 2989 Answers

SOURCE: how to remove starter from a 2005 chevy aveo

Please don't forget to rate....thank you:

  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
  3. Disconnect the starter electrical harness.
  4. Remove the starter ground bolt.
  5. Support the starter and remove the bolts.
  6. Remove the starter from the vehicle.

73fcc2b.gif The location of the starter


To install:
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Install the starter. Tighten the mounting bolts to 32 ft. lbs. (43 Nm) on 2005 models. Tighten the solenoid nut to 11 ft. lbs. (15 Nm).
  3. Install the ground bolt and tighten to 30 ft. lbs. (41 Nm).
  4. Connect the starter electrical harness.
  5. Connect the negative battery cable.

Posted on May 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace clutch of a 2004 Chevy Aveo


Here's a link on your clutch.Here's how to remove transmission.

Oct 16, 2013 | Vehicle Parts & Accessories

1 Answer

How to remove starter from a 2005 chevy aveo


Please don't forget to rate....thank you:

  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
  3. Disconnect the starter electrical harness.
  4. Remove the starter ground bolt.
  5. Support the starter and remove the bolts.
  6. Remove the starter from the vehicle.

73fcc2b.gif The location of the starter


To install:
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Install the starter. Tighten the mounting bolts to 32 ft. lbs. (43 Nm) on 2005 models. Tighten the solenoid nut to 11 ft. lbs. (15 Nm).
  3. Install the ground bolt and tighten to 30 ft. lbs. (41 Nm).
  4. Connect the starter electrical harness.
  5. Connect the negative battery cable.

May 04, 2010 | 2005 Chevrolet Aveo

1 Answer

Where is the starter solonoid located 04 aveo


You will need to verify if the starter solenoid is getting power when you are attempting to crank it. I dont have a diagram, but the clutch switch may be the problem if you must depress the clutch to start the engine.

Jan 16, 2010 | 2004 Chevrolet Aveo

2 Answers

Rear speakers for Chevy Aveo


you can access them from under the package tray inside your trunk compartment

Aug 26, 2009 | 2004 Chevrolet Aveo

2 Answers

2004 Chevy Aveo sounds like turning over but not starting


could be damaged flywheel or bad starter remove starter and have it tested while starter is removed check flywheel

Jul 10, 2009 | 2004 Chevrolet Aveo

1 Answer

We took apart the car but need to put the timing belt back in


Get the right timing belt part and tensioner asembly,
It will come withthe instruction manual in the box from NAPA ,,, autozone, etc.
The belt will have white marks that corespond to marks on puleys,
Remove no 1 plug , insert ruber hose turn engine to top point TDC.
Folow instructions on suplied sheet.
Vitally

Jun 02, 2009 | 2004 Chevrolet Aveo

2 Answers

Ma brain box dammaged


d78d9a3.jpg
My brain box dammage, this is a picture

Nov 17, 2008 | 2006 Chevrolet Aveo

4 Answers

Remove a cd player from a Chevrolet Aveo


how do you remove a factory radio from a 2008 chevy aveo L T

May 14, 2008 | 2005 Chevrolet Aveo

Not finding what you are looking for?
Chevrolet 2004 Chevrolet Aveo Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Audio Players & Recorders Experts

D. E. Hev

Level 3 Expert

1187 Answers

Marvin
Marvin

Level 3 Expert

85160 Answers

Lawrence Oravetz

Level 3 Expert

10543 Answers

Are you a Chevrolet Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...