Question about Dirt Devil CE6100 Featherlite Upright Vacuum
1.make sure that the sol tank is in there correctly. 2. when putting the machine together, the upper handle assembly goes on but you have to screw it down, if it is screwed down, the only thing that is left is the pump assembly that the guide rod hits. the rod hits this button inside of the machine and sometimes this gets jamed or all together stops working. the cause for this is usually from putting the wrong sol in the machine. hope this helps
Posted on Jul 20, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Mar 07, 2016 | Vacuums
Oct 14, 2014 | Dyson DC44 Animal Cordless Vacuum
Jul 07, 2014 | Hoover Floormate H3000 Upright Wet/Dry...
Jun 19, 2014 | Hoover SteamVac Carpet/Upholstery Deep...
Jun 02, 2014 | Hoover Steamvac F5860-900 Vacuum
Mar 09, 2014 | Bissell PowerForce PowerBrush Deep...
Aug 16, 2011 | Vacuums
1) Make sure there is water in the solution tank.
2) Try priming the machine by instructing the consumer to squeeze the trigger
repeatedly for 1 to 2 full minutes. Important: If you cannot
squeeze the trigger all the way in, remove the tank from the back of the
machine and then try squeezing the trigger with the tank removed. There is an
internal valve that could be sticking. By removing the solution tank and squeezing
the trigger, it should break it loose, allowing the trigger to be fully depressed.
3) Make sure the open end of the siphon tube in the solution tank is not pushed into the
side of the tank, covering the end of tube. If it is, push the bend in the
Siphon tube toward the back of the solution tank.
4) Check to see if the siphon tube has become disconnected from the outlet fitting on
the inside of the solution tank. If so, you need to buy a replacement solution tank. Parts
can be found at www.bissell.com
5) Check to see if air comes through the spray tip by repeatedly squeezing the trigger
with solution tank off the unit. If not, spray tip may be clogged. Try and unclog
spray tip with a pin or paper clip.
If still no spray, please check the following:
a) Make sure the solution tank is installed properly.
b) Check to see if black O-ring is present on rear connector to solution tank.
May 28, 2011 | Bissell 1716 Spot Lifter PowerBrush...
Feb 26, 2011 | Vacuums
Mar 21, 2010 | Bissell Powersteamer 1694 Upright Vacuum
159 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: