Question about Canon imageRUNNER 2016 All-In-One Laser Printer
Dear, check all the ccd flat cables of scanner unit and dc boards back side and replace them which are faulty due to long time which lost the metallic strength for which this issue comes .One flat cable is fitted from scanner lamp unit to its board which is long cable and two flat cables are fitted with this scanner board to back side pcb which are long and another one is connected to two pcb boards at back side one comes from mother board to other board,
Posted on Nov 09, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
E064 The presence of a high-voltage error is communicated by the composite power supply PCB. (The output for primary charging, developing, or transfer
has deviated from a specific level of voltage.)
Main cause The contact has poor connection. The wiring is faulty. The composite power supply PCB is faulty. The DC controller PCB is faulty.
Is any of the contacts of the primary charging roller, developing assembly, or transfer charging roller soiled? Or, is there poor contact?
YES: Clean the contact, and set it once again.
Is the wiring between the contacts for the following normal: DC controller
PCB (J301), composite power supply PCB (J136), primary charging roller, developing assembly, transfer charging roller?
a. DC controller PCB (J301) <-> composite power supply PCB (J136)
b. composite power supply PCB (J130-7) <-> primary charging roller contact
c. composite power supply PCB (J130-1) <-> developing assembly contact
d. composite power supply PCB (FT133) <-> transfer roller contact
NO: Correct the connection.
3. Composite power supply PCB, DC controller PCB
Try replacing the composite power supply PCB. Is the problem corrected?
NO: Replace the DC controller PCB.
Posted on Feb 26, 2009
SOURCE: Error E007 canon IR 2016
An error in the rotation of the fixing film is detected.
The reading of the main thermistor is 100°C or higher and, in addition, the fixing film sensor does not detect the rotation of the film for 6 sec or more while the fixing motor is driven.
To clear the error, execute the following in service mode: -
to open service mode press star press 2 and 8 key same time then press star again.
Is there a fault in the fixing film edge rotation detection mechanism?
YES: Replace the fixing film unit.
Posted on Mar 05, 2009
Tips for a great answer:
Oct 16, 2016 | Canon imageRUNNER 2016 All-In-One Laser...
service mode > copier > adjust > adjust xy > adjust Y input the value from the label on the front cover
This is all I could find. Try adjusting by 1/4 inch. Thank you Santosh
Jun 25, 2016 | Canon imageRUNNER 3035 Black and White...
Jan 20, 2016 | Canon CANNON IR2016 COPIER FOR 220 VOLTS...
Sep 01, 2011 | Canon iR 2016i Black and White Copier
Nov 16, 2010 | Canon iR 2016i Black and White Copier
Oct 20, 2010 | Computers & Internet
May 29, 2010 | Canon iR 2016i Black and White Copier
Nov 20, 2009 | Canon PC-940 Black and White Copier
May 23, 2008 | Sharp AR-M350N Copier
269 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: