Question about Blaupunkt Televison & Video

Open Question

I changed my blaupunkt 49 inch tv over to media settings and it instantly went on to standby mode now nothing works stuck with red light on.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Panasonic Viera TH-42PV7HS Plasma keeps shutting down

Hi to all, My 42" Panasonic plasma have the same problem. It turned itself off and now red light flashes 7 times, than after short pause 7 times again. And so on. Any ideas what is wrong??

Posted on Oct 23, 2008

Ad
  • 1 Answer

SOURCE: Olevia 437-S11 stuck in standby mode

My classroom TV seems to be stuck in standby mode. Blue light is on but TV won't turn on either by push button or remote.

Posted on Nov 06, 2008

ginko
  • 19396 Answers

SOURCE: tv has got stuck on standby mode

If the TV goes off completely, then is usually a faulty power board.

If the TV goes in standby, then it is in protection mode.

Ensure also that the fault is not coming from a faulty receiver box sending
bad signal, check if you get same problem on DVD with no receiver box
connected.

Try first leaving the TV power cord unplugged for some times, let say one hour or so.

The flashing light indicates a diagnostic state called protection.
When the TV goes on protection there are only two possible causes.

1The internal circuits are jammed because of electrostatic charges accumulating on capacitors, or because of a wrong voltage read by the main chip on your monitor controller board. this started the protection circuit.

2 The protection circuit detected a wrong voltage or abroken contact, identified an internal fault and kicked in , starting the flashing light.

If you are in situation one, then the TV will reset just unplugging power cord for one or two hours,sometimes even minutes.

If you are in situation 2 , then there is an internal fault.

If under warranty contact the manufacturer ringing the number on the user manual

If you want to repair at your own expenses, just locate any good qualified repairer.

If you want to DIY you find parts here,

All: Appliance parts, electronics parts & more from PartStore.com

Encompass Parts Distribution

LCD/Plasma Electronic Replacement Parts: Plasma & LCD TVs, Appliances |


On LCD Pay particular attention at inverter and power board, power board can be inspected looking for bulged or leaking capacitors, then tested with a multimeter. The inverter is more difficult to test , there is need to read voltages, should be done by a tech. Also the LCD controller board can cause same problem

On Plasma, test Sustain (Ysus/Zsus) / Buffer boards , cables to plasma, digital board and power board.

On Rear Projection : check lamp, lamp ballast, power board, and convergence.

On CRT TVs, check ballast , flyback transformer, CRT, Tuner, Convergence.

Posted on Apr 29, 2009

  • 9 Answers

SOURCE: INSIGNIA LCD won't turn on

replace 2 condensers in the power supply with greater voltage ones.original are 1000uf 35volt...use 1000uf 65volt...99cents each
power circuit is made to fail with typical tv industry tactics...the warranty is reflected by the life of their condensors (capacitors) average life is 2000 hours..
easy...huh
if your a smoker...you must clean the button cover as they get stuck on with your stupid tobacco residue. 75% of all LCD tv's that smokers own fail this way...
\tough huh?
TRY TO STOP SMOKING...

Posted on May 18, 2009

  • 1 Answer

SOURCE: help my sony bravia just today got stuck in

When I power my Sony lcd 42 inch the red light blinks then I push the power button the green standbye light just continues to blink, any suggestions

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What does it mean when your tv states standby and you cannot turn it on or off with the remote control?


How to Fix a Sony Plasma TV With a Standby Problem ...

smallbusiness.chron.com > Finances & Taxes > Other Finances & Taxes
A standby mode problem on your plasma TV can result in the TV being stuck instandby mode, ... You can troubleshoot a standby mode error by performing a power cycle or restoring the TV to its factory settings. ... Turn the television on. ... What Does It Mean When My Rumor Touch Says the Camera Is in Standby Mode?

tv on standby mode cant get it off - TV - Streaming Video & TVs

www.tomsguide.com/answers/id-1676193/standby-mode.html

Dec 27, 2015 | Televison & Video

1 Answer

Ive just bought a 22 inch lg tv, tuned in ok but remote is now not working, wont do anything, wont even put tv in standby mode. Any ideas?


unplug tv, take batteries out of remote. plug tv back in, replace batteries. best idea i have. sometimes that resets the devices. good luck

Mar 05, 2015 | LG 22LV2500 22" Inch 720p Widescreen LED...

1 Answer

LG 42in Class 1080p 120Hz LCD HDTV red light stays


Hi
Your tv set is stuck in the standby mode as a components went shortcircuit in one of the power supply rails and should be serviced by qualified personnel.

Sully

Sep 29, 2013 | LG 42LC2D 42 in. LCD HDTV

1 Answer

Emerson 32 inch won't come out of standby mode


It clearly has a problem not allowing it to come on---the set has a warranty---take it back and either get an exchange---Most major stores will exchange in first 30 days for any reason---if they give you the "it has to go for repair," demand a refund on the spot.

Frankly Emerson is not a very good quality brand and parts and support are nearly zero.

Dec 04, 2012 | Televison & Video

1 Answer

TV will not turn on, stuck on red standby light


What is the Brand name of your TV? Visit the site named 'Electro-help' for more details. Click this link. View it in "Timeslide" option, which can be selected from the drop down box menu by the [Sidebar] tag, at the top left corner of the display window. It will make search easy. There are more than 1000 posts to different brand TVs now. Pull up older posts there

Oct 16, 2012 | Televison & Video

1 Answer

Tv went off while watching a program power standby red light blinks 6 times then pauses then repeats tried unplugging unit waiting a few minutes then replugged same results nothing. can anyone help me ?...


Here's an excerpt from the Sony Manual online. And the link - http://esupport.sony.com/US/perl/webtree.pl?template=EN&mdl=KDF55XS955&content_id=68&category_id=11&problem_id=52

The POWER/STANDBY (red) indicator flashes three times
If your power/standby indicator is flashing in a pattern of three flashes, this may indicates that the lamp cover is not attached securely. Follow the directions in the Operating Manual under changing your lamp that related to closing and securing the Lamp Cover. Ensure that the Lamp Cover Door is securely fastened by tightening each screw.

The POWER/STANDBY (red) indicator flashes continously
If your power/standby indicator is flashing continuously, and the lamp cover has been secured, your TV may be in need of service.

The POWER/STANDBY indicator is lit up green (not flashing)
A sustained green light indicates your TV is on.

The POWER/STANDBY indicator is lit up red (not flashing)
A sustained red light from your power/standby indicator simply indicates that your TV is in standby mode. This shows you that your TV is ready to be turned on with the remote.

Is it the power light and not the lamp light? If the lamp light is flashing then replace the lamp.

Apr 07, 2009 | Sony Grand WEGA KDF-55XS955 55" Rear...

3 Answers

The Power Light is Red


yeah, should stay red when unit is turned off, indicating there's power but it's doing nothing.

Per user manual:
Solid red - power off (standby mode)
blinking red - power off (now cooling)
blinking green - power on (preparing to light lamp)
solid green - power on

Mar 08, 2009 | Panasonic PT-40LC12 40" Rear Projection...

1 Answer

Tv stuck in standby


Your problem is in the switch mode power supply or the horizontal out circut.
sometimes the small CHOKE that feeds the base of the horz. out transistor has a cold solder joint.
resolder both ends first.
Thanks Guy9

Jun 10, 2008 | Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Blaupunkt Televison & Video Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Vernon Taylor

Level 3 Expert

5747 Answers

antoniorojas

Level 2 Expert

280 Answers

Are you a Blaupunkt Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...