Question about Blaupunkt Televison & Video
It sounds to me that you no longer have standby voltage. If you are good with a multimeter, I would measure voltages on your power supply, check the fuse, and see if there are any burned components or bulging capacitors. Also check that you have your right voltage from the wall. Trying an outlet you know that works would be good if you don't have a multimeter.
Posted on Oct 30, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If your set was manufactured around July 2005, you may need a firmware upgrade to solve this issue. On the Sony website you can enter your model # and serial # to see if you TV is affected. If so, it is easy to have done and may be free from Sony. It sounds like the issue they described in the writeup on the required formware update. I had mine done within few months of when i bought it (purchased in Dec 2005) and it has been working flawlessly since.
Posted on Oct 21, 2008
the lamp is simple; yet you can run into problems with this tv. be very careful replacing lamp. the plug in the tv can be damaged. (due to the design)
lamp part #
Posted on Mar 13, 2009
You are going to have to troubleshoot all the boards in the television until you find the problem. Start with power supply board. This part usually goes bad due to overheating and faulty components. You must check for brown spots on the boards , that are signs of overheating. Look for bad components like bulging capacitors and burnt resistors.Look for bad connections, like cold solder joints. you must be very careful working on the power supply board as it does have high voltages they can be very dangerous to the inexperienced user. Never test anything with the power on or connected.Use anti static protection straps and gloves around all the chips and microprocessors to avoid damaging them. Check all the other boards for the same problems. If you can find no problems, Then it is time to get help from a service center where they will have all the necessary testing equipment, To give the unit a more thorough testing for faulty components.Hope this helps you with your problem.
Posted on May 17, 2009
Tips for a great answer:
Feb 27, 2011 | Samsung Televison & Video
Jun 27, 2010 | Televison & Video
May 21, 2010 | Panasonic PT-53WX54 53" Rear Projection...
Jan 15, 2018 | Toshiba 62HMX95 62" HDTV
Mar 13, 2009 | Mitsubishi WD-62526 Projection TV
742 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: