Question about Samsung Office Equipment & Supplies
Front cover of back cover sensor needs to be checked
Posted on Oct 03, 2018
Take the toner waste unit out and all cartridges, then take the fusing unit out . turn it to the side and shake all of the waste toner out of the fusing unit( be careful not to bang the fusing units rollers) when this is done blow out the printer and fusing unit( do not put your hands on the fusing unit) and the toner is poisonous , so wear a mask and gloves. the reason the error occurs is because the fusing unit has to much waste toner in it and it can't push it into the waste toner unit, so its getting stuck in the fusing unit and then you get a red light for waste toner unit full when it really isnt full but the fusing unit is. good luck all .hope it helps someone
Posted on Oct 01, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The waste dispenser (next to the toner cartridges) probably needs to be emptied out. That's what always sets off the red light for me.
Posted on Nov 15, 2008
I have to open the front panel as though I were going to replace the toner cartridge, but, instead I pull out the toner reclamation cartridge (the gray "L" shaped one to the left of the cyan cartridge) and then put it back in. This has cleared it each time for me.
Posted on Jan 15, 2009
You can try see if this may do it.
Go to Start / Run and type in "services.msc" without quotation marks, then press Enter or click OK.
In the window that opens (Services) look for "Print Spooler" on the right
Right-click "Print Spooler" and select "Properties".
Click on the "Recovery" tab and change all 3 drop-down boxes to "Restart The Service".
Make sure the 2 text boxes underneath say "1" in them.
Click Ok until you are back at the Services window, close it and you're good to go.
Go back into the properties of the "Print Spooler" tab and be sure to click Start to restart the Print Spooler service and it will restart the service immediately.
The Print spooler depends on the Remote Procedure Call (RPC) service. Is this service disabled? Go to services.msc look for RPC. Check state: Automatic
Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks
Posted on May 04, 2010
Tips for a great answer:
Oct 30, 2017 | Samsung Clp-325 Colour Laser Printer
Jun 22, 2011 | Samsung CLP 315 Laser Printer
Mar 17, 2011 | Samsung CLP 300 Laser Printer
Sep 27, 2010 | Samsung CLP 300 Laser Printer
Status LED light is Red and the Toner lights are OFF (Check Smart Panel for message)
Status LED light is Blinking/Flashing Red and the Toner light(s) are Red
Status LED light is Red and the Toner light(s) are Red
Sep 25, 2010 | Samsung CLP 315 Laser Printer
Jun 28, 2010 | Samsung CLP 300 Laser Printer
Nov 22, 2009 | Samsung ML 1710 Laser Printer
Jun 18, 2008 | Samsung CLP 300 Laser Printer
127 people viewed this question
Usually answered in minutes!