Question about Turbo Air Refrigerators

Open Question

Turbo air model msf-49nm f2 error flashing

Unit runs for a really long time and when turned of it takes over 4 hrs to kick back on fans on the evaporator coil run but no compressor and no fan on condensing unit

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 143 Answers

SOURCE: GE Central A/C Unit about 30 yrs old; condenser fan stops after a short time.

I gather that it is the outdoor fan motor that runs a bit then stops.

Fan motors that stop by themselves are overheating and going into self-protect. The fact that you replaced the motor and capacitor opens up a whole world of "which wire is in the wrong place". I could do this if I could see it, but I can't see it. You're probably going to wind up calling a service man to sort out the wiring.

Posted on Jul 25, 2008

Ad
peyton32034
  • 410 Answers

SOURCE: Model is GSS25WGMD WW No cooling in freezer or refrigerator

look for ice or forst build up on the rear wall of freezer compartment, sounds like you may have a defrost problem. this will affect temps in freezer and refrig. the most common def problems for GE are bad defrost heaters. these are model specific and fairly easy to replace your self. i got this part number form Sears.com WR51X10055 good luck peyton

Posted on Jan 20, 2009

SOURCE: Evaporator fan did not start running when condenser fan started.

I don't know why there would be much of a delay between the condenser and evaporator fans coming on. If you have diagnosed it as a bad motor, that's probably correct.

But the motor could just need cleaning and lubricating

Posted on Apr 28, 2009

  • 4 Answers

SOURCE: Blowing hot air, compressor not kicking on, just fan ? ?

are you speaking of the outside fan or inside? compressor should be a little warm but not boiling hot. the unit could be low on freon. if low it will run a while but the compressor will overheat and shut off leaving the fan running by itself ouside. if nothing outside is running check power. if you have power check the contacted outside to make sure it's pulled in. contacters are bad about going out on goodman untis. Also ants can get under contacts.

Posted on Jun 18, 2009

  • 534 Answers

SOURCE: Amana Cooling Condensing Unit fan won't kick on

be aware that not repairing this asap that you are causing yourself more problems First I would change out the fan capacitor and see if this could be the problem. Secondly if the capacitor isn,t the problem change out the motor . By continuing to allow the system to cycle like this the compressor will take a dive on you costing more . Good Luck

Dave

Posted on Aug 04, 2009

Testimonial: "Yes, it's dual run capacitor problem. I used a stick to spin the fan blades and it starts to slowly spin and up to normal speed, so motor is good."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my evap coil and fans covered in snow


Hello,

The heater is supposed to be on the inside of your drain line.

Sep 01, 2014 | Turbo Air New Maximum Two Door Freezer -...

1 Answer

Turbo air frz goes into defrost compressor continous to run. Does not stop during defrot


Hi, Please set your thermostat a bit warm and observe the compressor. Also check your freezer for leaking.

Nov 06, 2010 | Turbo Air 49 cu. ft. / 1388 liter...

1 Answer

Defrost times and adjust


http://www.turboairinc.com/TB-Service/Service%20Manual%20%20-%20April%202008/TSF-49SD.pdf

go to this site and check out the service manual. I guessed at the unit you had as you did not include the model number.
You can also go to turboairinc.com and search for more info if you need to.

Hope this gets you your answer.

Apr 15, 2010 | Turbo Air 49 cu. ft. / 1388 liter...

1 Answer

Msf-49nm will not stay below freezing!!


My next question is, you say you have to call a tech to come out. Is he doing something? And if so, what? With the limited info I have at this time, it sounds like there may be a refrigerant problem. Let me know so we can continue. Am looking forward to resolving this.

Jun 02, 2009 | Turbo Air 49 cu. ft. / 1388 liter...

1 Answer

Compressor gos to overlaod


sound like a bad start capacitor,if you have a capactance check on your multimeter,you can find the readings on the side of the cap.I always replace the relay,overload and capacitor at the same time. this usually keeps me from coming back and having to replace another part in a short amount of time. Also check and make sure your condensor coil is clean , let me know if you need more help


Mar 31, 2009 | Turbo Air 49 cu. ft. / 1388 liter...

1 Answer

Msf-49nm evaportor pan and drain iced up


I deal with MasterBilt which is a private lable made by TurboAir.
I have several units but only one does this icing up thing. Look for a bad seal on the door gasket. These really ice up if that does not seal almost perfectly. Look for premature termination of the defrost cycle. Check that the heater is pulling amps. The wiring diagram at "turboairinc.com" is very poor but it shows 2 heaters for the refrigerator. They list a diagram for the freezer but it's not there. I know for sure that there is a heater for the evap but don't know about the drain. I've seen some have it and some don't. there tech support line has much to be desired but it's worth a shot. Also, the bottom hinge on the door fails fairly regularly. This allows the door to drop just enought to disengage the switch at the top of the door and stop the evap fan from running, thus causing a freeze up.
Good Luck . You got your hands full with this one.

Dec 11, 2008 | Turbo Air 49 cu. ft. / 1388 liter...

1 Answer

Set tempature on minus 5 unit doen't shot down runs all the time.


It sounds to me very likely that your thermostat isn't functioning properly. change the settings and wait to see if it responds. If the thermostat is working it should shut down the compressor when you increase (rise) the temperature and aversly start it when you drop the temperature. Always let the unit sit for 3 minutes for the pressure inside to equalize before restarting. Good Luck

Nov 19, 2008 | Turbo Air 49 cu. ft. / 1388 liter...

Not finding what you are looking for?
Refrigerators Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Turbo Air Refrigerators Experts

Dennis Boxerman

Level 3 Expert

1300 Answers

Lawrence Oravetz

Level 3 Expert

10543 Answers

Raj Patel

Level 3 Expert

1041 Answers

Are you a Turbo Air Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...