Question about Al Agnew Watches
If you know the movement you can search on how to do this, There normally is a lever or a push pin hold that needs to be pressed down to remove the stem.
Posted on Oct 07, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Often with battery powered watches the word "Quartz" will be written on the dial. In the abscent of that you can look at the mechanism inside (typically by removing the case back).
Alternately (this may not be an absolute confirmation) with the winder in neutral position i.e. pressed all the way in, turn the crown (winding button) and if it spins freely it's probably quartz. Because unless it's broken most mechanical watches click as the watch is
wound up (except some automatics which cant be crown wound).
Plus if it's working and left unworn for a few days yet continues to run it's probably quartz.
Please rate this solution.
Posted on Jul 27, 2009
First you must say what type as there are differences depending on the mfg and model.Be the following basics apply.
1- Put the stem in the setting position (usually pulled out if stem set).
2 Them open cover to expose the movement. ( Screw off or snap open).
3- Remove the movement (Usually held in place with 2 screws at the outer edge.
4-Then if there is a screw in the part that holds the stem loosen that.
5- The stem can be held with a pair of pliers on the flat and the crown unscrewed. Be careful not to damage the square (FLATS), with the pliers. A rag or other safety measure should be taken.
6- then inside the stem hole, looking from the ouside the is an annular area around the stem that has a ferrule screwed into the case this has to be unscrewed and will bring out the stem and the ferrule.
This siounds complicated but the steps are more involved to write than they are to perform.
There are many variations to this process, and each type should be understood before proceeding.
Posted on Nov 24, 2009
did you figuer it out because i am having the same problem, i don't want to take apart the balance just to change the and fix the face
Posted on Nov 26, 2009
Tips for a great answer:
Jun 30, 2013 | Watches
Jun 21, 2012 | Colibri Pocket Watch Hunting Case Moon...
Sep 20, 2010 | Adidas Response Light Twin watch #ADP1701...
Mar 02, 2010 | Al Agnew Al Ag 3 Piece Pocket Watch...
Feb 14, 2010 | Elgin Watches
Jul 26, 2009 | Al Agnew Al Ag 3 Piece Pocket Watch...
Mar 20, 2009 | Watches
Mar 19, 2009 | Colibri Mechanical Collection Pocket...
Feb 27, 2009 | Watches
Dec 15, 2007 | Watches
91 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: