Question about Hotpoint Dryers
From early on, this dryer would just "shut down" when a "normal sized" load was put in and the setting for heat was set to "Cottons/Regular" - the highest of three heat settings. After 15 minutes, I could restart it until it happened again, and again until the clothes were dry. Two remedies to this problem were to use the Wrinkle Free medium setting, which would take 2 - 3 times longer to dry each load, and pulling the entire dyer to the center of the small laundry room - thus extending the heat exhaust to about 4 feet (instead of the 12-18 inches direct to the outside vent). Research revealed this problem was normal for this model, so I just adapted as needed. Now, the dryer does no heat at any setting. The drum rotates and air circulates, but no heat. I have a service contract for labor only, but the service techs who they send always seem to diagnose that the parts needed to repair this dryer (and the past one) exceed the cost of the dryer itself (often with multiple parts and kits that have been unnecessary for the repair ... which has usually been a $15 part I could get at an electrical supply store). I suspect this is the same situation.
If it uses a pilot light check to see if it is lit. If no pilot the electric starter is probably bad. If no pilot does it make light buzzing as it is trying to start, if not the starter is bad.
Posted on Oct 31, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the gas coils have a problem. as the dryer heats p the coils on the gas valve are failing causing the dryer not to heat. replace the coils and you should have no problem
Posted on Oct 23, 2007
first, check your exhaust, you have to make sure there is no buildup at all inside it. this is the most common problem to cause this. if lint gets backed up, there is a sensor that shuts down the heating element after only a few seconds. hope this helps
Posted on Oct 28, 2008
SOURCE: Poorly heating clothes dryer
Best way to test the elements and stats is to disconnect each one in turn, and with your meter set on the ohms range ,test each one in turn for continuity, you should get F.S.D.(full scale deflection) on each component.
Another way to test the element, is to bypas the stats, and connect the 240v suplly directly to the element, it should get red hot, but do not leave it on for more than a few seconds..
If it had gone down to earth, then theoretically it should trip the circuit breaker.
Plz rate my solution.
Posted on Dec 25, 2008
I had the same problem with mine. My wrinkle free setting some how got turned off. As soon as I turned that back on machine kept running and dried the clothes fine.
Posted on Mar 28, 2009
Tips for a great answer:
Apr 21, 2017 | Hotpoint Dryers
Apr 08, 2015 | Whirlpool Dryers
Sep 11, 2014 | Dryers
Aug 18, 2014 | Maytag Dryers
Nov 27, 2012 | Hotpoint Ultima WF860 Front Load Washer
Aug 06, 2011 | Whirlpool GGW9868K Gas Dryer
Aug 01, 2011 | Dryers
Apr 13, 2011 | Bosch Axxis WTA 3510 Electric Dryer
Nov 08, 2010 | Hotpoint Dryers
79 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: