Question about Connex Radio Communications

1 Answer

Have connex 4600 turbo ,using 636 and d104 mic. not happy with clearity . what shouid I do. DAVE

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,642 Answers

Posted on Jan 17, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 11 Answers

SOURCE: my connex 4600 turbo was doing ok just not walking

It's probably a bad ground connection at the antenna. The coax shield needs to have a good ground (ground plane) or else you'll have RF feedback through the mic cable due to excessive RF traveling back down the outside of the coax and making the radio "hot".

Posted on Oct 10, 2009

  • 20 Answers

SOURCE: Connex 4600 Turbo

Every tech. knows and every Connex owner Knows that once a Connex has been peaked and tuned and also had any mods done to it that the stock microphone that comes with it will not work as it should and then you will have bad feed back!! The best solution for this is buy a good Noise canceling microphone!! Such as an RK-56 or an Astatic 636-L Noice canceling microphone!! This usually will correct most of tghe feedback if not all of it!! And it will also let you keep most of your Mic gain turned uo too.

Posted on Jan 16, 2010

Mister 44
  • 35 Answers

SOURCE: connex 4600 turbo radio stays keyed up even with

Bad RX/TX Transistor? I don't have a diagram for the 4600. Sorry!

Posted on Apr 03, 2010

  • 1 Answer

SOURCE: I have a Connex 4600

Had the same problem. Try backing off the RF gain just a bit (about 4 o'clock ) and set mic gain 2 o'clock or lower ...that worked for mine ..it is still plenty loud

Posted on Feb 10, 2011

anymhz
  • 500 Answers

SOURCE: I have a connex 4600 turbo very good radio!! But

check for any loose power connections.. ground connections.. loose coax.. also make sure vehicle is on so not to drain battery down when TXing. if it was off it may have dropped battery voltage down lower than it should... and turned off.. RX doesn't use hardly any ampres..

Posted on Mar 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Will a connex 4600 turbo cb radio operate cool enough in a dash enclosure?


I have CX-4600-T too. Mine gets way hot as well, I had a mod kit installed n it swings 215W peak power now. But the excessive heat is annoying, I think mine does have a fan in it though cause I know I felt air coming out the back before.
12_19_2018_5_04_40_am.jpg

May 26, 2014 | Connex 4600 Base CB Radio

1 Answer

What is the best power mic for the ranger vr 9000


Astaic 36L. You never want to run a power Mike with a good radio with Mic Gain. Road King is great to. It is very hard to find the honey spot with a power Mike when you have Mike gain on radio.I think it is pretty hard to beat the 36L. I use one one my Connex 4600 Turbo and Galaxy 95T2, They both performe great. Connex is a little better a DX ing though

Nov 22, 2013 | Ranger VR-9000 Base CB Radio

1 Answer

I av a connex 4600 turbo and a astatic 636 mic on it when i turn the talk on it squeals bad how do u stop it


turn down the rf gain. If that doesn't work you may want to have some one install 2 .001 caps across the tx and the dx wires in the mic.

Mar 18, 2013 | Radio Communications

1 Answer

I have a connex 4600 turbo very good radio!! But the other day I keyed up my mic and the radio shut off but came right back on when let go. Do u know what that might be?


check for any loose power connections.. ground connections.. loose coax.. also make sure vehicle is on so not to drain battery down when TXing. if it was off it may have dropped battery voltage down lower than it should... and turned off.. RX doesn't use hardly any ampres..

Mar 28, 2011 | Connex Radio Communications

2 Answers

I have a Connex 4600 Turbo mounted in the headliner of a W900L Kenworth using Wilson 2000 twin antennas and a RK56 mic. When trying to use the "talk-back" feature all I hear is constant...


Strange. You shouldn't have a squealing problem with an RK56 noise canceling mic.

Unfortunately there is no way to change the volume of the talkback. Its too loud. The only solution is to turn the mic gain down.

The only reason you need to have talkback on is to check your audio. Make sure the echo is good and what not. After that you really don't need it on. So turn down the mic gain, then check the echo, then turn off the Talkback and turn the gain back up.

The squeal is feedback from the talkback being to loud and being heard by the mic. So the only way to solve it is to lower the volume of the talkback, (Which is not possible in this radio) lowering the mic gain(which lowers your audio level) or turning it off.

Nov 08, 2010 | Connex 4600 Base CB Radio

1 Answer

Connex 4600 turbo radio stays keyed up even with mic disconected


Bad RX/TX Transistor? I don't have a diagram for the 4600. Sorry!

Mar 28, 2010 | Connex 4600 Base CB Radio

1 Answer

Connex 4600 turbo the talk back


THE TALK BACK VOLUME IS CONTROLLED BY THE MIC GAIN, TRY ADJUSTING YOUR TALK BACK VOLUME ABOUT TURNING THE MIC GAIN FROM 12 OCLOCK TO 6 OCLOCK, DO NOT WORRY YOU WILL NOT LOSE ANY OUT BOUND POWER UNLESS YOU TURN THE MIC GAIN BELOW 11 OCLOCK

Mar 29, 2009 | Connex 4600 Base CB Radio

4 Answers

Connex 4600 Turbo


i have the same radio turn talk back off and there is enough power ull have talk back through you trucks radio speakers and it needs to be hooked up to the battery with at least 12ga wire

Feb 10, 2009 | Connex 4600 Base CB Radio

Not finding what you are looking for?
Radio Communications Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Connex Radio Communications Experts

Chris

Level 2 Expert

197 Answers

Damon Nesselrodt
Damon Nesselrodt

Level 2 Expert

197 Answers

Ray Murphy

Level 2 Expert

68 Answers

Are you a Connex Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...