Question about GE Dishwashers
I did press and hold "Select Cycle" and "Start" for Five seconds. Since all the LED's flashed I am assuming that the dishwasher thinks that the door is open. Will simply replacing the door latch fix this problem? Is the correct part WD21X10490?
Usually has a microswitch that connects when the door is closed. Check to see where the switch is and check to see if it is connecting.
Posted on Jun 04, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
You need a new door latch mechanism.
It is faulty and not doing it's job of over riding when the door is opened
Please remember to leave a solved rating before leaving
Posted on Dec 19, 2008
That means the control sensed that the heater in the d/w did not operate 3 times in a row. so the unit locks out. First remove the kick plate and you may have to pull the unit out from under the cab, but check your heater. use a meter to see if it reads open, if so order a heater assy it will come with a new control replace it to. If your heater checks good press in sequence normal wash , heat dry ,normal wash,heat dry , normal wash , heat dry three times within 6 sec all the lights will come on then hit cancel. What that did is reset the control and clear that fault. Keep in mind that d/w does not heat it's own water your incoming water temp should be 120. the d/w will maintain that temp. when starting your d/w first turn on your hot water till it gets hot then start your d/w this insures your unit fills with hot water and not cold
Posted on Jan 09, 2009
holding the button for four seconds will not do it, you have to hold it until the light stops blinking and
will go back to normal, normall takes more than four seconds to unlock the unit, this is something
the sears repair techs know becouse the are trained on all this things but, they will not share this things, becouse thats how they make money
Posted on Apr 18, 2009
SOURCE: Faulty Dishwasher
1st 2 lights flashing is fault F03 meaning The drain pump has been energised for 4 minutes, but the pressure switch has not reset to the empty position.
The drain pump is fed from the wash pump; therefore an open circuit wash pump could stop the drain pump from working.
A jammed drain pump or blockage in the outlet hose or plumbing.
A blocked pressure chamber or pressure switch air tube.
A faulty pressure switch.
Check wiring to pump and module connections.
If all the above are OK, replace the module.
Posted on Dec 17, 2009
Tips for a great answer:
Jan 03, 2018 | Bosch Dishwashers
on Jun 17, 2011 | Washing Machines
Apr 06, 2016 | Bosch SHE4AP06UC Dishwasher
Oct 11, 2014 | Whirlpool Dishwashers
Mar 04, 2012 | Whirlpool Dishwashers
Sep 10, 2011 | Whirlpool Gold 24 in. Built-In Dishwasher...
Jun 24, 2011 | GE Nautilus 24" Built-in Dishwasher
Jun 19, 2011 | Maytag Dishwasher
May 27, 2011 | Bosch Dishwashers
May 17, 2010 | Dishwashers
Jun 26, 2019 | GE Dishwashers
78 people viewed this question
Usually answered in minutes!