Question about Sanyo Televison & Video

1 Answer

I have a sanyo tv model Dp42849 it won't turn on. Little green light comes on but has a black screen.is there a reset button on the tv somewhere

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 67 Answers

Step 1 Press the "Power" button located at the top of your Sanyo remote control to turn your television on.
Step 2 Press the "Reset" button located next to the power button.
Step 3 Press the "Reset" key a second time to reset your Sanyo television and restore its factory settings.

Should you require further assistance. please reply to this directly
Thank you.

Posted on May 26, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 135 Answers

SOURCE: screen went black on my 42" sanyo model dp42647 lcd

Hi there! The panel may be in protection mode. The Inverter board is the most logical area to start after checking power supply Voltages.(5,6,24 and 13Volts). There may be coils on the Inverter Board which have bad soldering or faulty. Other than this it may be main board which controls switch on or off. If all else fails, refer to a repairer. Beware of High Current!!! Best Wishes and Good Luck, Jus004

Posted on Aug 23, 2009

  • 1 Answer

SOURCE: Sanyo CE26LD81B TV going from a red to green to blue screen

same arrrgggg

Posted on Jan 10, 2010

  • 8457 Answers

SOURCE: Sanyo 42" LCD will not turn on!!!

Power supply board is dead.Buy a refurbish power supply board at Shopjimmy.com,Ebay.com for the replacement.

Posted on Mar 26, 2010

  • 2 Answers

SOURCE: My Sanyo DP32649 Will not turn on. The green light

Sounds like the power supply is bad.Do you know anything about working on circuit boards ? I bet some of the capacitors need replacing.This is a quick and very cheap fix if you know how to do it.

On the back of the tv is a panel held by two screws.Remove those and you have instant access to the power supply.Look and see if any of the capacitors are bulging or leaking.

Posted on May 07, 2010

saryejade
  • 1 Answer

SOURCE: No sound and black screen

lets get together, start a list of names and sue companies selling crappy wares at way too high prices! email saryejade@aol.com

Posted on Oct 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sanyo dp42849 completely black screen, green light blinks every minute.


These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit stage inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. Viewing it in "Mosaic" or "Magazine" will make surf easy.
http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.

Apr 26, 2014 | Sanyo DP42849 42 in. HDTV

1 Answer

Hi my sister has a sanyo dp42849 when I turns on it flashes then goes black the green light that says its on stays on and there is sound


If there is sound output, means, the main baord is functioning well, and the problem is only with its display section. Check whether the back-light is ON or not. Check and replace the back light inverter, if back-light do not turn ON. check the voltage that comes to back-light board; from the main power board is present. If not, check out the reason. If you're sound in electronics, and wish to get more details, check this link. http://electronicshelponline.blogspot.com/ Selecting the view option, either to Mosaic / Flip card, can be selected by the drop-down list, by the top left of the display window, will make surf easy. You can also do a search, by type in the brand name / model number / IC used, in the search box at the top right of the display window.

Nov 03, 2013 | Sanyo DP42849 42 in. HDTV

1 Answer

I realized my Sanyo tv post may have been confusing.


There always is the possibility that the replacement power board is defective.

Aug 26, 2017 | Sanyo DP42849 42 in. HDTV

1 Answer

Sanyo DP42849 no picture but has sound


Sounds like an inverter problem. On some of these sets, the inverter and the power supply are on the same board. These boards tend to be quite pricey, $100 + range. I've worked on your particular model with the same problem, and it was a bad inverter/power supply board. I would recommend you get a diagnosis to be sure.

Oct 28, 2012 | Sanyo DP42849 42 in. HDTV

1 Answer

Where is the inverter board located in the sanyo dp42849


To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the case, you have to replace the main board.
http://electronicshelponline.blogspot.com/

Aug 22, 2012 | Sanyo DP42849 42 in. HDTV

1 Answer

The Tv screen is no longer coming up! The little green light comes on but the Tv doesn't power on! I bought it new in March 2010. It's just black.


Hello,
What you would do first is unplug the TV from the wall outlet and let it sit there for 30-60 seconds then plug it back into the wall.
Now if that hard reset did not work what you got here is a display fault, now many TV in this age would carry that 1 year parts warranty were you would seek out that warranty where you bought the tv.
Many people do not purchase extended warranties at the cash register and in my expert opinion why would you invest into the purchase of a TV and not fork $59.99 for extended warranties?
Extended warranties would cover this and more, part for this could cost you anywhere from $129- $200 Labor is also a huge wallet eater.
Now I could not tell you from here what exactly the issue is because I am not at the back of the TV nor anywhere within miles. So its basically hard reset or repair shop.
Hope this Helps,
Thanks for using fixya.com


Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Jun 30, 2011 | Sanyo DP42849 42 in. HDTV

4 Answers

Will not come on it worked fine earlier.


Plasma and LCD TV sets are prone to having capacitors in the power supply section fail. This is the most likely cause for the probem you describe. When capacitors fail your will commonly see one or more of the following symptoms.
  • No video, Power light is on or blinking.
  • TV is making a clicking noise.
  • TV takes a while to come on
  • Screen is very dim or flickers.

Again, You can get a power supply repair kit with the parts, detailed instructions, and support from sites such as www.TvRepairKits.com . Or just click here to see more details on their kit.

Here are pictures of capacitors...Notice that the ones below look bloated. They have failed and will need to be repalced.



ecollier2012.jpg
Capacitor being replaced! Fairly easy DIY fix.

ecollier2012_0.jpg
Again, You can get a power supply repair kit with the parts, detailed instructions, and support from sites such as www.TvRepairKits.com . Or just click here to see more details on their kit.

May 17, 2011 | Sanyo DP42849 42 in. HDTV

4 Answers

Hello my Sanyo dp42849 42 inch has no picture and no sound. when i turn on the tv a green light in the bottom right hand corner comes on and occasionally flashes off and then back on.


First, you need to know the sub-model of your TV.

It is called "chassis" and is shown on the back of the TV on the label where the model number is shown.

For example it can be "P42849-00" or "P42849-01".

Then search at www.coppelltvrepair.com/search or just go to www.coppelltvrepair.com and enter the link for SANYO DP SERIES to search for that.

Here's an example of a repair service (note it may NOT be the one for your exact model though!):

http://www.coppelltvrepair.com/p/41/sanyo-dp42849-p42849-00-does-not-power-on-repair-service

Hope this helps!

Jul 16, 2010 | Sanyo 42 in. LCD TV

1 Answer

Sanyo 42" LCD will not turn on!!!


Power supply board is dead.Buy a refurbish power supply board at Shopjimmy.com,Ebay.com for the replacement.

Mar 26, 2010 | Sanyo 42 in. LCD TV

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sanyo Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76060 Answers

 Grubhead
Grubhead

Level 3 Expert

5686 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1691 Answers

Are you a Sanyo Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...