Question about Electrical Supplies
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Your vehicle is equipaded with Factory Anti Theft System.
Called Pass key II . If the mechanic found the Code
Pass key error....
Is there a few test to Do. to know exactly the problem.
1--- check if the Old and New key Are equipaded with a Little thing (Chip or Ressistence) in the center of the key.
If not you need a key with the chip. and the correct Ohms.
2. If you just replace the battery,
Full charge the battery Attemp to start the vehicle and leave the key in run position for exactly 11 Minutes, Them turn the key to off position for 30 seconds and try to start, if the vehicle start . you did the prosses to program the key.
If the vehicle not start.
Some times this procedure will require Up to 3 times to setup.
Or more with intervals of 30 minutes,, But if not start.
Remove the lower cover of the steering column. and the the Connector orange with 2 white wires shielded with a orange cover.
NOTE.. Be sure to not Confuse with the Yellow wires and connector, They are for the AIR BAG. Dont use a Convencinal Test light on any of the Mentionated wires....
After you find the wire and saw everything ok.
3-- You will need to remove the Ignition Lock cylinder.
The ignition lock cylinder is use 2 white wires shielded with orange cover, On 90% of the cases one of the wires come broken. and the ECM loss the comunication with the Chip incrusted in the key..
Posted on Dec 27, 2008
You haven't given enough info to make a real diagnosis: Does it crank but not start or does it not crank. Ill take a guess: If the problem is not cranking hot, older ford starters used paper insulation that deteriorates over time. this will cause poor starter operation when hot, which usually is better cold. If problem is not with starter, next place I'd check is the ignition coil.
I could be wrong on both though...not enough info from you!
Posted on Mar 31, 2009
Sounds like a poor connection from either the positive or ground from the battery. Check connections at the battery, follow the cables to see if any other connections are loose.
Posted on Jun 24, 2009
Tips for a great answer:
Oct 02, 2018 | Holiday Rambler RVs
Sep 17, 2018 | Holiday Rambler RVs
May 11, 2018 | Holiday Rambler RVs
Dec 07, 2017 | Holiday Rambler RVs
Oct 23, 2017 | Holiday Rambler RVs
Aug 19, 2017 | Holiday Rambler RVs
Aug 14, 2017 | Holiday Rambler RVs
Aug 05, 2017 | Holiday Rambler RVs
Feb 20, 2017 | Holiday Rambler RVs
May 29, 2017 | John Deere Garden
Aug 20, 2019 | Electrical Supplies
25 people viewed this question
Usually answered in minutes!