Question about Cobra 148 GTL 120-Channels Base CB Radio
It has receive audio but no transmit audio on am or ssb, what is the problem
First take a jumper wire and connect it to the DC Ground of the input of the radio then touch it to the TX pin on the radio if it does keyes up then its in the mic or mic cord on the end of the mic plug or where it goes into the mic cable goes up inside the mic. If the radio don't key up at all then check the main voltage regulator chip one pin will have 8 volts transmit and another pin will have 8volts recieve. If you get no switching DC voltage on the regulator then its bad and needs replacing there is also a known bad capacitor in the radio thats only 10 volts change it to 25 volts at the same capacitance.
Posted on Jan 08, 2008
First off check to see if your mic gain is turned all the way down. Second; if you have a power mic is the battery dead ir the volume of the mic turned down. If these check ok, look for a loose or broken audio wire in your microphone, and the connector (both ends can break). I have seen the wires break as far back as 4 inches from the mic head and the connector depending on how the user held the microphone, or pulled against the wire. if the problem is not found to be any of the above I suggest you take the radio to a qualified technician for repair.
Posted on Dec 11, 2007
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Dec 02, 2013 | Cobra 148 GTL 120-Channels Base CB Radio
Jul 28, 2012 | Cobra 148 GTL 120-Channels Base CB Radio
Jun 11, 2011 | Cobra 148 GTL 120-Channels Base CB Radio
Aug 02, 2010 | Cobra 148 GTL 120-Channels Base CB Radio
Feb 06, 2009 | Cobra 148 GTL 120-Channels Base CB Radio
576 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: