Question about Washing Machines

Open Question

What is Whirpool Washing Machine Top Load EA ERROR?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
catriver
  • 878 Answers

SOURCE: F2 error code

Chia, this is not a good one, F2 is a keypad failure or interface mismatch. You can try a couple of things. 1. unplug the washer for a minute and see if the code returns. 2. Remove the consol to access the control board, three screws on the backside and the consol lifts up. On the right side you will see the main board. On the right side of the board, center harness will be the interface ribbon cable. Reseat it a couple of times. If this doesn't work, I believe you will have to replace the touchpad. Catriver.

Posted on Jan 13, 2008

Ad

SOURCE: My top load whirpool washing machine leaks during spin cycle.

it only does it on the small load? does the water drain out before it goes into spin?

Posted on Nov 14, 2008

  • 1 Answer

SOURCE: hi am getting e1 error in my washing machine

what is an E1 error message

Posted on Jan 04, 2010

  • 1531 Answers

SOURCE: Rusting lid on top-loading Kenmore Washing Machine

that is very possible.the best thing to do is replace the lid or sand all the rust off and you some rust inhibitive paint to helpslow or stop the rusting proccess.

Posted on Jan 23, 2010

Chesc
  • 59 Answers

SOURCE: Defy - 13KG Laundromaid 1300

Here's a solution I've gotten from one of the experts..

"Clean the drain motor lint tray/filter. So many 'faults' are caused by blocked filters. The motor is unable to drain all of the water in the allotted time.
If you are unsure where the filter is, it is normally behind the front lower (kick) panel (or in some machines at the rear in an awkward position!) and held in by a round cover/knob.

REMOVE POWER AND ENSURE YOU HAVE A WATER RECEPTACLE/RAGS TO SOAK UP THE WATER WHICH IS BOUND TO POUR OUT!

It's surprising what people have found in theirs! It is always worthwhile checking it on a regular basis.
Now- whilst the filter is removed it is normally possible to see the drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF!
At this point it is also possible to test if the motor works. No clothes or water in the machine, select a spin cycle and put the power back on. You should be able to see the motor turning at some point, possibly straight away. If it doesn't work then the motor is malfunctioning!"

Hope this helps.. Good luck! :)

Posted on Jun 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whirlpool whitemagic pro 700h


The model no is Whirpool whitemagic pro 700H fully automatic top load

Dec 19, 2013 | Washing Machines

1 Answer

Keep getting F1 error code on my cabrio whirpool top load washer. Can you help?


Hello & Welcome to FixYa

F1 error in your whirlpool cabrio indicates bad control board and should be replaced to resolve the error code. However, you can contact Whirlpool as well prior to replacing the control yourself as I have seen whirlpool paying for the parts themselves just because this is known to be a common issue. Please get back to me if you have any other questions.

Kevin

Sep 01, 2011 | Whirlpool Cabrio WTW6600SBT Top Load...

1 Answer

Hi I have a 5 cycle 2 speed top load whirpool washer and it all of a sudden will not go to the Spin Cycle and drain out the water. It stops in the rinse cycle. I need help!


Hi,

Problems with a washing machine not spinning or not draining are often interrelated..

If you are having a problem with your top load washer then check out thistip...

Washing Machine does not Pump or Spin


If you are having problems with your front load washing machine then checkoutthis tip...

Front Load Washing machine not draining and or not spinning


heatman101

Jun 25, 2011 | Washing Machines

1 Answer

My whirpool washer will not spin. Any suggestions?


Hi,

Problems with a washing machine not spinning or not draining are often interrelated..

If you are having a problem with your top load washer then check out thistip...

Washing Machine does not Pump or Spin


If you are having problems with your front load washing machine then checkoutthis tip...

Front Load Washing machine not draining and or not spinning


heatman101 .

Oct 11, 2010 | Whirlpool AWM6140 Front Load Washer

1 Answer

What's the capacity of a Simpson 175 HD washing machine (approx 22 years old). What new top load should i buy? dials or push button?


about 6to7 kg.to b honest the machines i find that last the longest r kleenmaid top loaders,maytag top loader,whirpool top loaders,and miele front loaders, i would try to advoid electronic units.nothing will b as robust as your 175.

Apr 06, 2010 | Washing Machines

1 Answer

Whirpool Duet Washing machine F-11 error


I purchased a Whirpool duel washing machine Aug 05. In June of 08 it showed an F11 error. After factory repair service tech. looked at it he said that i needed a main motor at a cost of $400.00 After search on internet many people reported problems also and decided not to repair it. Has any one had problems with theirs?Ihave the same problem is there any solution????please help

Jan 07, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Whirpool washing machine it won't spin after it drains water


Check if there looks like black powder under machine
This would be the coupling falling a part
It is worth fixing and not to hard
The part is under $10

Jun 06, 2009 | Whirlpool Ultimate Care II LSQ9564J Top...

1 Answer

Washing machine doesn't spin spindel


whirpool part# 80040 agitator dogs need replacing remove center cap remove bolt in agitator pull top section up ..may need to hold bottom down and pull up sharply on top section to separate

Nov 06, 2008 | Roper RAS6233KQ Top Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

Brad Brown

Level 3 Expert

18084 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...